SDA6000 Datasheet, PDF (267/380 Pages) Infineon Technologies AG – Teletext Decoder with Embedded 16-bit Controller

SDA 6000
Interrupts
Peripherals
Table 7-25
Interrupt
Data
Interrupt Sources
SRC Register
I²CTIC
Data Error
I²CTIC
Protocol: Arbitration Lost I²CPIC
Protocol: Slave Mode after I²CPIC
Lost Arbitration
Protocol: Slave Mode after I²CPIC
Device Address
Data Trans-mission End
after Stop Condition
I²CTEIC
Data Trans-mission End
after RSC Condition
I²CTEIC
Data Transmission End after I²CTEIC
missing Acknowledge
Description
Interrupt is requested after the
acknowledge bit of the last byte has
been received or transmitted.
Interrupt is requested if a multi byte
write could not be finished in slave
mode because of missing
acknowledge, then the data interrupt is
followed by an end of transmission
interrupt.
Interrupt is requested when the I²C
module has tried to become master on
the bus but has lost the arbitration.
Interrupt is requested if multimaster
mode is selected and the I²C module
temporarily switches to slave mode
after a lost arbitration.
Interrupt is requested if multimaster
mode is selected and the I²C module
temporarily switches to slave mode
after a lost arbitration.
Interrupt is requested after
transmission is finished by a stop
condition.
Interrupt is requested after
transmission is finished by a repeated
start condition (RSC).
Interrupt is also requested if a
transmission is stopped by a missing
acknowledge.
Users Manual
7 - 116
2000-06-15