SDA6000 Datasheet, PDF (109/380 Pages) Infineon Technologies AG – Teletext Decoder with Embedded 16-bit Controller

SDA 6000
Interrupt and Trap Functions
and N require external operand read accesses, instructions N-3 through N write back
external operands, and the interrupt vector also points to an external location. In this
case the interrupt response time is the time needed to perform 9 word bus accesses,
because instruction I1 cannot be fetched via the external bus until all write, fetch and
read requests from preceding instructions in the pipeline are terminated.
• When the interrupt vector, of the example above, is pointing into the internal code
memory, the interrupt response time is 7 word bus accesses plus 2 states because
the fetching of instruction I1 from internal code memory can start earlier.
• When instructions N, N+1 and N+2 are executed out of the external memory and the
interrupt vector points to an external location, but all operands for instructions N-3
through N are in internal memory, then the interrupt response time is the time needed
to perform 3 word bus accesses.
• When the interrupt vector, of the example above, is pointing into the internal code
memory, the interrupt response time is 1 word bus access plus 4 states.
After an interrupt service routine has been terminated by executing the RETI instruction,
and if further interrupts are pending, the next interrupt service routine will not be entered
until at least two instruction cycles of the program that was interrupted have been
executed. In most cases two instructions will be executed during this time. Only one
instruction will typically be executed if the first instruction following the RETI instruction
is a branch instruction (without cache hit), if it reads an operand from internal code
memory, or if it is executed out of the internal RAM.
Note: A bus access, in this context, includes all delays which can occur during an
external bus cycle.
5.2.4 PEC Response Times
The PEC response time defines the time between an interrupt request flag of an enabled
interrupt source being set and the PEC data transfer being started. The basic PEC
response time for the M2 is 2 instruction cycles.
Users Manual
5 - 25
2000-06-15