SDA6000 Datasheet, PDF(248/380 Page) Infineon Technologies AG – Teletext Decoder with Embedded 16-bit Controller

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

SDA6000 Datasheet, PDF (248/380 Pages) Infineon Technologies AG – Teletext Decoder with Embedded 16-bit Controller

◁

SSC0EN = 1: Operating Mode

SSCCON

SDA 6000

Peripherals

Reset Value: 0000H

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

SSC0 SSC0 - SSC0 SSC0 SSC0 SSC0 SSC0 -

-

-

-

EN MS

BSY BE PE RE TE

rw rw

r rw rw rw rw

SSC0BC

rw

Bit

SSC0BC

SSC0TE

SSC0RE

SSC0PE

SSC0BE

SSC0BSY

SSC0MS

SSC0EN

Function

SSC0 Bit Count Field

Shift counter is updated with every shifted bit. Do not write to!!!

SSC0 Transmit Error Flag

1: Transfer starts with the slaveâs transmit buffer not being updated

SSC0 Receive Error Flag

1: Reception completed before the receive buffer was read

SSC0 Phase Error Flag

1: Received data changes around sampling clock edge

SSC0 Baud Rate Error Flag

1: More than factor 2 or 0.5 between Slaveâs actual and

expected baud rate

SSC0 Busy Flag

Set while a transfer is in progress. Do not write to!!!

SSC0 Master Select Bit

0: Slave Mode. Operate on shift clock received via SCLK.

1: Master Mode. Generate shift clock and output it via SCLK.

SSC0 Enable Bit = â1â

Transmission and reception enabled. Access to status flags and M/S

control.

Note: The target of an access to SSCCON (control bits or flags) is determined by the

state of SSC0EN prior to the access, i.e. writing C057H to SSC0CON in

programming mode (SSC0EN = â0â) will initialize the SSC (SSC0EN was â0â) and

then switch it on (SSC0EN = â1â).

When writing to SSCCON, make sure that zeros are input to reserved locations.

The SSC0 baud rate timer reload register SSCBR contains the 16-bit reload value for

the baud rate timer.

Users Manual

7 - 97

2000-06-15

▷