C8051F124-GQR Datasheet, PDF (247/350 Pages) Silicon Laboratories – Mixed Signal ISP Flash MCU Family

C8051F120/1/2/3/4/5/6/7
C8051F130/1/2/3
SFR Definition 18.3. XBR2: Port I/O Crossbar Register 2
R/W
R/W
R/W
WEAKPUD XBARE CNVST2E
Bit7
Bit6
Bit5
R/W
T4EXE
Bit4
R/W
T4E
Bit3
R/W
UART1E
Bit2
R/W
R/W
Reset Value
EMIFLE CNVST0E 00000000
Bit1
Bit0
SFR Address: 0xE3
SFR Page: F
Bit7:
Bit6:
Bit5:
Bit4:
Bit3:
Bit2:
Bit1:
Bit0:
WEAKPUD: Weak Pullup Disable Bit.
0: Weak pullups globally enabled.
1: Weak pullups globally disabled.
XBARE: Crossbar Enable Bit.
0: Crossbar disabled. All pins on Ports 0, 1, 2, and 3, are forced to Input mode.
1: Crossbar enabled.
CNVST2E: External Convert Start 2 Input Enable Bit.
0: CNVSTR2 unavailable at Port pin.
1: CNVSTR2 routed to Port pin.
T4EXE: T4EX Input Enable Bit.
0: T4EX unavailable at Port pin.
1: T4EX routed to Port pin.
T4E: T4 Input Enable Bit.
0: T4 unavailable at Port pin.
1: T4 routed to Port pin.
UART1E: UART1 I/O Enable Bit.
0: UART1 I/O unavailable at Port pins.
1: UART1 TX and RX routed to 2 Port pins.
EMIFLE: External Memory Interface Low-Port Enable Bit.
0: P0.7, P0.6, and P0.5 functions are determined by the Crossbar or the Port latches.
1: If EMI0CF.4 = ‘0’ (External Memory Interface is in Multiplexed mode)
P0.7 (/WR), P0.6 (/RD), and P0.5 (ALE) are ‘skipped’ by the Crossbar and their
output states are determined by the Port latches and the External Memory Interface.
1: If EMI0CF.4 = ‘1’ (External Memory Interface is in Non-multiplexed mode)
P0.7 (/WR) and P0.6 (/RD) are ‘skipped’ by the Crossbar and their output states are
determined by the Port latches and the External Memory Interface.
CNVST0E: ADC0 External Convert Start Input Enable Bit.
0: CNVST0 for ADC0 unavailable at Port pin.
1: CNVST0 for ADC0 routed to Port pin.
Rev. 1.4
247