C8051F124-GQR Datasheet, PDF (221/350 Pages) Silicon Laboratories – Mixed Signal ISP Flash MCU Family

C8051F120/1/2/3/4/5/6/7
C8051F130/1/2/3
SFR Definition 17.2. EMI0CF: External Memory Configuration
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset Value
-
-
PRTSEL EMD2 EMD1 EMD0 EALE1 EALE0 00000011
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
SFR Address: 0xA3
SFR Page: 0
Bits7–6:
Bit5:
Bit4:
Bits3–2:
Bits1–0:
Unused. Read = 00b. Write = don’t care.
PRTSEL: EMIF Port Select.
0: EMIF active on P0–P3.
1: EMIF active on P4–P7.
EMD2: EMIF Multiplex Mode Select.
0: EMIF operates in multiplexed address/data mode.
1: EMIF operates in non-multiplexed mode (separate address and data pins).
EMD1-0: EMIF Operating Mode Select.
These bits control the operating mode of the External Memory Interface.
00: Internal Only: MOVX accesses on-chip XRAM only. All effective addresses alias to on-
chip memory space.
01: Split Mode without Bank Select: Accesses below the 8 k boundary are directed on-chip.
Accesses above the 8 k boundary are directed off-chip. 8-bit off-chip MOVX operations use
the current contents of the Address High port latches to resolve upper address byte. Note
that in order to access off-chip space, EMI0CN must be set to a page that is not contained in
the on-chip address space.
10: Split Mode with Bank Select: Accesses below the 8 k boundary are directed on-chip.
Accesses above the 8k boundary are directed off-chip. 8-bit off-chip MOVX operations use
the contents of EMI0CN to determine the high-byte of the address.
11: External Only: MOVX accesses off-chip XRAM only. On-chip XRAM is not visible to the
CPU.
EALE1–0: ALE Pulse-Width Select Bits (only has effect when EMD2 = 0).
00: ALE high and ALE low pulse width = 1 SYSCLK cycle.
01: ALE high and ALE low pulse width = 2 SYSCLK cycles.
10: ALE high and ALE low pulse width = 3 SYSCLK cycles.
11: ALE high and ALE low pulse width = 4 SYSCLK cycles.
Rev. 1.4
221