C8051F124-GQR Datasheet, PDF (128/350 Pages) Silicon Laboratories – Mixed Signal ISP Flash MCU Family

C8051F120/1/2/3/4/5/6/7
C8051F130/1/2/3
DATA BUS
ACCUMULATOR
TMP1
TMP2
PSW
ALU
B REGISTER
STACK POINTER
SRAM
ADDRESS
REGISTER
SRAM
(256 X 8)
DATA BUS
BUFFER
D8
DATA POINTER
D8
PC INCREMENTER
SFR_ADDRESS
SFR
SFR_CONTROL
D8
BUS
SFR_WRITE_DATA
INTERFACE
SFR_READ_DATA
PROGRAM COUNTER (PC)
PRGM. ADDRESS REG.
RESET
CLOCK
CONTROL
LOGIC
PIPELINE
STOP
IDLE
POWER CONTROL
REGISTER
D8
D8
MEM_ADDRESS
MEM_CONTROL
MEMORY
A16
INTERFACE ^{MEM_WRITE_DATA}
MEM_READ_DATA
D8
INTERRUPT
INTERFACE
D8
SYSTEM_IRQs
EMULATION_IRQ
Figure 11.1. CIP-51 Block Diagram
Programming and Debugging Support
A JTAG-based serial interface is provided for in-system programming of the Flash program memory and
communication with on-chip debug support logic. The re-programmable Flash can also be read and
changed by the application software using the MOVC and MOVX instructions. This feature allows program
memory to be used for non-volatile data storage as well as updating program code under software control.
The on-chip debug support logic facilitates full speed in-circuit debugging, allowing the setting of hardware
breakpoints and watch points, starting, stopping and single stepping through program execution (including
interrupt service routines), examination of the program's call stack, and reading/writing the contents of reg-
isters and memory. This method of on-chip debug is completely non-intrusive and non-invasive, requiring
no RAM, Stack, timers, or other on-chip resources.
The CIP-51 is supported by development tools from Silicon Labs and third party vendors. Silicon Labs pro-
vides an integrated development environment (IDE) including editor, macro assembler, debugger and pro-
grammer. The IDE's debugger and programmer interface to the CIP-51 via its JTAG interface to provide
fast and efficient in-system device programming and debugging. Third party macro assemblers and C
compilers are also available.
128
Rev. 1.4