M16C80 Datasheet, PDF (353/358 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/80 SERIES

M16C/80 Group
Revision History
Version
Contents for change
Rev.1.0 _{Page 136 Figure 16.12 Special mode register 3 'SDAi digital delay time set bit' --> revised}
001: 1 to 2 cycles of 1/f(XIN)
010: 1 to 2 cycles of 1/f(XIN)
011: 1 to 2 cycles of 1/f(XIN)
100: 1 to 2 cycles of 1/f(XIN)
101: 1 to 2 cycles of 1/f(XIN)
110: 1 to 2 cycles of 1/f(XIN)
111: 1 to 2 cycles of 1/f(XIN)
Page 150 Figure18.5 /P --> P revised
Page 152 Typical transmit/receive timing in UART mode (compliant with the SIM interface)
Diagram revised
Page 153 (a) Function for outputting a parity error signal
With the error signal output enable bit ... TxDi pin when a parity error is detected.
--> During reception,with the error signal output enable bit ... TxDi pin when a parity
error is detected.
In step with this function, ... of a parity error signal. --> deleted
Therefore parity error signals ... interrupt program. --> added
And during transmission, ... of the transfer clock. --> added
Page 160 the baud rate generator --> the UARTi bit rate generator
baud rate generator stops counting. -->the count stops
Page 160 UART2 Special Mode Register 2 (Address 033616) --> UARTi Special Mode
Register 2(i=2 to 4) (Address 033616,032616,02F616), SCL2 --> SCLi, SDA2 -->
SDAi, UART2 --> UARTi revised
Page 161 UART2 Special Mode Register 3(Address 033516) --> UARTi Special Mode
Register 3(i=2 to 4 )(Address 033516,032516,02F516)
SDA2 --> SDSi revised
Page 163 Figure 20.6 Special mode register 3 'SDAi digital delay time set bit' --> revised
001: 1 to 2 cycles of 1/f(XIN)
010: 1 to 2 cycles of 1/f(XIN)
011: 1 to 2 cycles of 1/f(XIN)
100: 1 to 2 cycles of 1/f(XIN)
101: 1 to 2 cycles of 1/f(XIN)
110: 1 to 2 cycles of 1/f(XIN)
111: 1 to 2 cycles of 1/f(XIN)
Page 176 Set the function select register A... --> Set the function select register A3...
Page 193 Figure 26.2, P74, P75, P80 move to (inside dotted-line included)
Page 208 Timer --> added
Page 209 (5) If an exernal triger input is used to start counting, the next external triger input
must be avoided within 300ns before the timer A reaches "0000h". --> added
Page 210 Timer B (pulse period/pulse width measurement mode)
(4) --> added
Revision
date
02/08/'05
C- 13