M16C80 Datasheet, PDF (341/358 Pages) Renesas Technology Corp – RENESAS 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/80 SERIES

M16C/80 Group
Revision History
Version
Contents for change
Revision
date
REV.B
• Page 1 line 5
1 M byte --> 16 M bytes
• Page 1 line 15 10 MHz with software one wait --> 10 MHz : under planning
• Page 1 line 16 35 mW (f(XIN)=20MHz, without software wait, Vcc=5V; M30800MC-
XXXFP target value ) --> 45 mA (M30800MC-XXXFP)
• Page 1 X-Y converter ---- 1 circuit Addition
• Page 4 line 28 35 mA --> 45 mA
• Page 6 figure 1.1.4
• Page 18 figure 1.5.4 and corresponding pages
(106) Peripheral subfunction select register --> Function select register C
(107) Port function select register 0 --> Function select register A0
(108) Port function select register 1 --> Function select register A1
(109) Peripheral function select register 0 --> Function select register B0
(110) Peripheral function select register 1 --> Function select register B1
(111) Port function select register 2 --> Function select register A2
(112) Port function select register 3 --> Function select register A3
(113) Peripheral function select register 2 --> Function select register B2
• Page 21 figure 1.6.3
Register name change same as figure 1.5.4
• Page 24 figure 1.8.1
Processor mode register 0
Note 6 --> Note 7, Note 6 Addition
Processor mode register 1 Note 3
• Page 31 line 4
Addition: The ALE signal is occurred regardless of internal area and external area.
__
_____ ______
• Page 31 table 1.10.4, Page 33 table 1.10.5 R/W --> RD/WR
• Page 42 table 1.11.4 System clock control register 0 Note 2
• Page 51 line 7, table 1.15.1
port function select register 3 (address 03B516) --> port function select register 3 (ad-
dress 03B516) and D/A control register (address 039C16)
• Page 60 line 3 the interrupt occurs. --> the interrupt can be set to occur on input signal
level and input signal edge.
• Page 65 line 10 Set register --> When writing to DCT2, DCT3, DRC2, DRC3, DMA2 and
DMA3, set register
• Page 67 table 1.20.2 Addition: Note 5
• Page 86 line 1 successively when --> successively two times when
• Page 93 line 16 Count source input --> Count source input (Set the corresponding func-
tion select register A to I/O port.)
• Page 114 table 1.25.6, page 122 table 1.26.1
UARTi transmit/receive mode register Addition: Note 2
UARTi transmit/receive mode register Addition: Note 3
• Page 115 table 1.25.7 UARTi transmit/receive mode register 0 Delate: Note 3
• Page 120 line 13 Addition: -Set the corresponding function select register A to I/O port
• Page 123 table 1.26.3
• Page 130 table 1.27.3
• Page 139 figure 1.29.2
• Page 142 line 2 062316 --> 032616
• Page 144 table 1.29.5
• Page 156 table 1.31.2 D/A control register (Note) Addition: Note
____
• Page 164 figure 1.34.2 16-bit bus mode A9 --> A9
• Page 165 line 5 f32 --> BCLK(frequency x 32)
'98. 10.19
C- 1