MC68HC08AZ60A Datasheet, PDF (243/480 Pages) Motorola, Inc – Microcontrollers

Serial Communications Interface (SCI)
I/O Registers
16.9.5 SCI Status Register 2
SCI status register 2 contains flags to signal the following conditions:
• Break character detected
• Incoming data
Address: $0017
Bit 7
6
5
4
3
2
1
Bit 0
Read: 0
0
0
0
0
0
BKF
RPF
Write:
Reset: 0
0
0
0
0
0
0
0
= Unimplemented
Figure 16-16. SCI Status Register 2 (SCS2)
BKF — Break Flag Bit
This clearable, read-only bit is set when the SCI detects a break
character on the RxD pin. In SCS1, the FE and SCRF bits are also
set. In 9-bit character transmissions, the R8 bit in SCC3 is cleared.
BKF does not generate a CPU interrupt request. Clear BKF by
reading SCS2 with BKF set and then reading the SCDR. Once
cleared, BKF can become set again only after logic 1s again appear
on the RxD pin followed by another break character. Reset clears the
BKF bit.
1 = Break character detected
0 = No break character detected
MC68HC08AZ60A — Rev 0.0
MOTOROLA
Serial Communications Interface (SCI)
Advance Information
243