MC68HC08AZ60A Datasheet, PDF (237/480 Pages) Motorola, Inc – Microcontrollers

Serial Communications Interface (SCI)
I/O Registers
SBK — Send Break Bit
Setting and then clearing this read/write bit transmits a break
character followed by a logic 1. The logic 1 after the break character
guarantees recognition of a valid start bit. If SBK remains set, the
transmitter continuously transmits break characters with no logic 1s
between them. Reset clears the SBK bit.
1 = Transmit break characters
0 = No break characters being transmitted
NOTE:
Do not toggle the SBK bit immediately after setting the SCTE bit.
Toggling SBK before the preamble begins causes the SCI to send a
break character instead of a preamble.
16.9.3 SCI Control Register 3
SCI control register 3:
• Stores the ninth SCI data bit received and the ninth SCI data bit to
be transmitted.
• Enables the following interrupts:
– Receiver overrun interrupts
– Noise error interrupts
– Framing error interrupts
– Parity error interrupts
Address: $0015
Bit 7
6
5
4
3
2
1
Bit 0
Read: R8
T8
R
Write:
R
ORIE NEIE FEIE PEIE
Reset: U
U
0
0
0
0
0
0
= Unimplemented
R = Reserved
U = Unaffected
Figure 16-13. SCI Control Register 3 (SCC3)
MC68HC08AZ60A — Rev 0.0
MOTOROLA
Serial Communications Interface (SCI)
Advance Information
237