MC68HC08AS32 Datasheet, PDF (216/280 Pages) Motorola, Inc – M68HC08 Family of 8-bit microcontroller units (MCUs)

WRITE TO SPDR ¹
SPTE
3
2
8
5
10
SPSCK (CPHA:CPOL = 1:0)
MOSI
SPRF
MSB BIT BIT BIT BIT BIT BIT LSB MSB BIT BIT BIT BIT BIT BIT LSB MSB BIT BIT BIT
654321
654321
654
BYTE 1
BYTE 2
BYTE 3
4
9
READ SPSCR
6
11
READ SPDR
7
12
1 CPU WRITES BYTE 1 TO SPDR, CLEARING
SPTE BIT.
2 BYTE 1 TRANSFERS FROM TRANSMIT DATA
REGISTER TO SHIFT REGISTER, SETTING SPTE BIT.
3 CPU WRITES BYTE 2 TO SPDR, QUEUEING
BYTE 2 AND CLEARING SPTE BIT.
4 FIRST INCOMING BYTE TRANSFERS FROM SHIFT
REGISTER TO RECEIVE DATA REGISTER, SETTING
SPRF BIT.
5 BYTE 2 TRANSFERS FROM TRANSMIT DATA
REGISTER TO SHIFT REGISTER, SETTING SPTE BIT.
6 CPU READS SPSCR WITH SPRF BIT SET.
7 CPU READS SPDR, CLEARING SPRF BIT.
8 CPU WRITES BYTE 3 TO SPDR, QUEUEING
BYTE 3 AND CLEARING SPTE BIT.
9 SECOND INCOMING BYTE TRANSFERS FROM SHIFT
REGISTER TO RECEIVE DATA REGISTER, SETTING
SPRF BIT.
10 BYTE 3 TRANSFERS FROM TRANSMIT DATA
REGISTER TO SHIFT REGISTER, SETTING SPTE BIT.
11 CPU READS SPSCR WITH SPRF BIT SET.
12 CPU READS SPDR, CLEARING SPRF BIT.
Figure 14-12. SPRF/SPTE CPU Interrupt Timing
The transmit data buffer allows back-to-back transmissions without the slave
precisely timing its writes between transmissions as in a system with a single data
buffer. Also, if no new data is written to the data buffer, the last value contained in
the shift register is the next data word to be transmitted.
For an idle master or idle slave that has no data loaded into its transmit buffer, the
SPTE is set again no more than two bus cycles after the transmit buffer empties
into the shift register. This allows the user to queue up a 16-bit value to send. For
an already active slave, the load of the shift register cannot occur until the
transmission is completed. This implies that a back-to-back write to the transmit
data register is not possible. The SPTE indicates when the next write can occur.
Data Sheet
216
MC68HC08AS32 — Rev. 4.1
Freescale Semiconductor