1N4007 Datasheet, PDF (74/236 Pages) Naina Semiconductor ltd. – General Purpose Rectifier 1.0A

TMS320C6652, TMS320C6654
SPRS841D – MARCH 2012 – REVISED JUNE 2016
www.ti.com
TIME
1
2a
2b
2c
3
4a
4b
5
6
7
8
9
10
Table 6-2. Core-Before-IO Power Sequencing
SYSTEM STATE
Begin Power Stabilization Phase
• CVDD (core AVS) ramps up.
• POR must be held low through the power stabilization phase. Because POR is low, all the core logic that has async reset
(created from POR) is put into the reset state.
• CVDD1 (core constant) ramps at the same time or shortly following CVDD. Although ramping CVDD1 and CVDD
simultaneously is permitted, the voltage for CVDD1 must never exceed CVDD until after CVDD has reached a valid voltage.
• The purpose of ramping up the core supplies close to each other is to reduce crowbar current. CVDD1 should trail CVDD as
this will ensure that the WLs in the memories are turned off and there is no current through the memory bit cells. If,
however, CVDD1 (core constant) ramps up before CVDD (core AVS), then the worst-case current could be on the order of
twice the specified draw of CVDD1.
• Once CVDD is valid, the clock drivers should be enabled. Although the clock inputs are not necessary at this time, they
should either be driven with a valid clock or be held in a static state with one leg high and one leg low.
• The DDRCLK and SYSCLK1 may begin to toggle anytime between when CVDD is at a valid level and the setup time before
POR goes high specified by t6.
• Filtered versions of 1.8 V can ramp simultaneously with DVDD18.
• RESETSTAT is driven low once the DVDD18 supply is available.
• All LVCMOS input and bidirectional pins must not be driven or pulled high until DVDD18 is present. Driving an input or
bidirectional pin before DVDD18 is valid could cause damage to the device.
• DVDD15 (1.5 V) supply is ramped up following DVDD18. Although ramping DVDD18 and DVDD15 simultaneously is
permitted, the voltage for DVDD15 must never exceed DVDD18.
• RESET may be driven high any time after DVDD18 is at a valid level. In a POR-controlled boot, RESET must be high before
POR is driven high.
• POR must continue to remain low for at least 100 µs after power has stabilized.
End Power Stabilization Phase
• Device initialization requires 500 SYSCLK1 periods after the Power Stabilization Phase. The maximum clock period is 33.33
nsec, so a delay of an additional 16 µs is required before a rising edge of POR. The clock must be active during the entire
16 µs.
• RESETFULL must be held low for at least 24 transitions of the SYSCLK1 after POR has stabilized at a high level.
• The rising edge of the RESETFULL will remove the reset to the efuse farm allowing the scan to begin.
• Once device initialization and the efuse farm scan are complete, the RESETSTAT signal is driven high. This delay will be
10000 to 50000 clock cycles.
End Device Initialization Phase
• GPIO configuration bits must be valid for at least 12 transitions of the SYSCLK1 before the rising edge of RESETFULL
• GPIO configuration bits must be held valid for at least 12 transitions of the SYSCLK1 after the rising edge of RESETFULL
74
Detailed Description
Copyright © 2012–2016, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Links: TMS320C6652 TMS320C6654