C8051F02X Datasheet, PDF (268/272 Pages) Silicon Laboratories – 8K ISP FLASH MCU Family

C8051F020/1/2/3
24.2. Flash Programming Commands
The Flash memory can be programmed directly over the JTAG interface using the Flash Control, Flash Data, Flash
Address, and Flash Scale registers. These Indirect Data Registers are accessed via the JTAG Instruction Register.
Read and write operations on indirect data registers are performed by first setting the appropriate DR address in the
IR register. Each read or write is then initiated by writing the appropriate Indirect Operation Code (IndOpCode) to the
selected data register. Incoming commands to this register have the following format:
19:18
IndOpCode
17:0
WriteData
IndOpCode: These bit set the operation to perform according to the following table:
IndOpCode
0x
10
11
Operation
Poll
Read
Write
The Poll operation is used to check the Busy bit as described below. Although a Capture-DR is performed, no
Update-DR is allowed for the Poll operation. Since updates are disabled, polling can be accomplished by shifting in/
out a single bit.
The Read operation initiates a read from the register addressed by the DRAddress. Reads can be initiated by shifting
only 2 bits into the indirect register. After the read operation is initiated, polling of the Busy bit must be performed to
determine when the operation is complete.
The write operation initiates a write of WriteData to the register addressed by DRAddress. Registers of any width up
to 18 bits can be written. If the register to be written contains fewer than 18 bits, the data in WriteData should be left-
justified, i.e. its MSB should occupy bit 17 above. This allows shorter registers to be written in fewer JTAG clock
cycles. For example, an 8-bit register could be written by shifting only 10 bits. After a Write is initiated, the Busy bit
should be polled to determine when the next operation can be initiated. The contents of the Instruction Register
should not be altered while either a read or write operation is busy.
Outgoing data from the indirect Data Register has the following format:
19
18:1
0
0
ReadData
Busy
The Busy bit indicates that the current operation is not complete. It goes high when an operation is initiated and
returns low when complete. Read and Write commands are ignored while Busy is high. In fact, if polling for Busy to
be low will be followed by another read or write operation, JTAG writes of the next operation can be made while
checking for Busy to be low. They will be ignored until Busy is read low, at which time the new operation will ini-
tiate. This bit is placed ate bit 0 to allow polling by single-bit shifts. When waiting for a Read to complete and Busy is
0, the following 18 bits can be shifted out to obtain the resulting data. ReadData is always right-justified. This allows
registers shorter than 18 bits to be read using a reduced number of shifts. For example, the results from a byte-read
requires 9 bit shifts (Busy + 8 bits).
268
Rev. 1.4