W90P710_05 Datasheet, PDF (63/526 Pages) Winbond – 16/32-bit ARM microcontroller

W90P710
BITS
[31:3]
[2]
[1]
[0]
RESERVED
DESCRIPTION
MIDLE
PD
IDLE
Memory controller IDLE enable
Setting both MIDLE and IDLE bits HIGH will let memory controller
enter IDLE mode, the clock source of memory controller will be halted
while ARM CORE enter IDLE mode.
1=memory controller will be forced into IDLE mode, (clock of memory
controller will be halted), when IDLE bit is set.
0 = memory controller still active when IDLE bit is set.
NOTE: Software must let SDRAM enter self-refresh mode before
enable this function because SDRAM MCLK will be stopped.
Power down enable
Setting this bit HIGH will let W90P710 enter power saving mode. The
clock source 15M crystal oscillator and PLLs are stopped to generate
clock. User can use nIRQ[3:0], keypad and external RESET to wakeup
W90P710.
1 = Enable power down
0 = Disable
IDLE mode enable
Setting this bit HIGH will let ARM Core enter power saving mode. The
peripherals can still keep working if the clock enable bit in CLKSEL is
set. Any nIRQ or nFIQ to ARM Core will let ARM CORE to exit IDLE
state.
1 = IDLE mode
0 = Disable
USB Transceiver Control Register (USBTXRCON)
REGISTER ADDRESS
USBTXRCO
N
0xFFF0_0030
R/W
R/W
DESCRIPTION
USB Transceiver Control Register
RESET VALUE
0x0000_0000
31
30
29
28
27
26
25
24
RESERVED
23
22
21
20
19
18
17
16
RESERVED
15
14
13
12
11
10
9
8
RESERVED
7
6
5
4
3
2
1
0
RESERVED
USBHnD
- 63 -
Publication Release Date: January 17, 2005
Revision A.2