W90P710_05 Datasheet, PDF (197/526 Pages) Winbond – 16/32-bit ARM microcontroller

W90P710
BITS
[31:8]
[7]
CCMD
[6]
VCMD
[5]
SIE_RCV
[4]
SUS_TST
[3]
RWU_EN
[2]
SUSP
[1]
USB_RST
[0]
USB_EN
DESCRIPTIONS
Reserved
USB Class Command Decode Control Enable
0: Disable, the H/W circuit doesn’t need to decode USB class command.
It will return a stall status when it received a USB Class Command.
1: Enable, the H/W circuit decodes USB class command. It will assert
an interrupt event when it received a USB Class Command.
USB Vendor Command Decode Enable
0: Disable, the H/W circuit doesn’t need to decode USB vendor
command. It will return a stall status when it received a USB Vendor
Command.
1: Enable, the H/W circuit decodes USB vendor command. It will assert
an interrupt event when it received a USB Vendor Command.
USB SIE Differential RCV Source
0: RCV generated by the SIE
1: RCV generated by the USB transceiver
USB Suspend Accelerate Test
0: Normal Operation
1: USB Suspend Accelerate Test (Only for Test)
USB Remote Wake-up Enable
0: Disable USB Remote Wake-Up Detect
1: Enable USB Remote Wake-Up Detect
USB Suspend Detect Enable
0: Disable USB Suspend Detect
1: Enable USB Suspend Detect
USB Engine Reset
0: Normal operation
1: Reset USB Engine
USB Engine Enable
0: disable USB Engine
1: enable USB Engine
Note: set this bit to “0”, the device is absent from host. After set
this bit to “1”, the host will detect a device attached.
- 197 -
Publication Release Date: January 17, 2005
Revision A.2