W90P710_05 Datasheet, PDF (106/526 Pages) Winbond – 16/32-bit ARM microcontroller

W90P710
Tx Descriptor Word 2
31
30
29
CCNT
23
22
21
LC
TXABT
NCS
15
14
13
7
6
5
28
27
Reserved
20
19
EXDEF
TXCP
12
11
TBC
4
3
TBC
26
SQE
18
Reserved
10
2
25
PAU
17
DEF
9
1
24
TXHA
16
TXINTR
8
0
CCNT [31:28]: Collision Count
The CCNT indicates the how many collision occurred consecutively during a packet transmission. If
the packet incurred 16 consecutive collisions during transmission, the CCNT will be 4’h0 and bit
TXABT will be set to 1.
SQE [26]: SQE Error
The SQE indicates the SQE error found at end of packet transmission on 10Mbps half-duplex mode.
The SQE error check will only be done while both bit EnSQE of MCMDR is enabled and EMC is
operating on 10Mbps half-duplex mode.
1’b0: No SQE error found at end of packet transmission.
1’b0: SQE error found at end of packet transmission.
PAU [25]: Transmission Paused
THE PAU INDICATES THE NEXT NORMAL PACKET transmission process will be paused temporally
because EMC received a PAUSE control frame, or S/W set bit SDPZ of MCMDR and make EMC to
transmit a PAUSE control frame out.
1’b0: Next normal packet transmission process will go on.
1’b1: Next normal packet transmission process will be paused.
TXHA [24]: Transmission Halted
The TXHA indicates the next normal packet transmission process will be halted because the bit TXON
of MCMDR is disabled be S/W.
1’b0: Next normal packet transmission process will go on.
1’b1: Next normal packet transmission process will be halted.
- 106 -