MC68HC08AZ16 Datasheet, PDF (398/527 Pages) Motorola, Inc – HCMOS Microcontroller Unit

Specifications
Control Timing
Control Timing
Characteristic
Symbol
Min
Max
Unit
Bus Operating Frequency (4.5–5.5 V — V_DD Only)
f_BUS
—
8.4 M
Hz
RESET Pulse Width Low
t_RL
1.5
—
t_cyc
IRQ Interrupt Pulse Width Low (Edge-Triggered)
t_ILHI
1.5
—
t_cyc
IRQ Interrupt Pulse Period
t_ILIL
Note 3
—
t_cyc
EEPROM Programming Time per Byte
t_EEPGM
10
—
ms
EEPROM Erasing Time per Byte
t_EBYTE
10
—
ms
EEPROM Erasing Time per Block
t_EBLOCK
10
—
ms
EEPROM Erasing Time per Bulk
t_EBULK
10
—
ms
EEPROM Programming Voltage Discharge Period
t_EEFPV
100
200
µs
16-Bit Timer (see Note 2)
Input Capture Pulse Width (see Note 3)
Input Capture Period
t_TH, t_TL
2
—
t_cyc
t_TLTL
Note 4
—
MSCAN Wake-up Filter Pulse Width (see Note 5)
t_WUP
2
5
µs
1.V_DD = 5.0 Vdc ± 0.5v, V_SS = 0 Vdc, T_A = –40 °C to +85 °C, unless otherwise noted.
2.The 2-bit timer prescaler is the limiting factor in determining timer resolution.
3.Refer to Table 2. Mode, edge, and level selection on page290 and supporting note.
4.The minimum period t_TLTL or t_ILIL should not be less than the number of cycles it takes to execute the capture interrupt
service routine plus TBD t_cyc.
5. The minimum pulse width to wake up the MSCAN module is guaranteed by design but not tested.
5-specs
MOTOROLA
Specifications
MC68HC08AZ32
397