MC68HC908GR16 Datasheet, PDF (183/310 Pages) Motorola, Inc – Microcontrollers

Freescale Semiconductor, Inc.
Enhanced Serial Communications Interface (ESCI) Module
I/O Registers
In applications that are subject to software latency or in which it is important to
know which byte is lost due to an overrun, the flag-clearing routine can check
the OR bit in a second read of SCS1 after reading the data register.
NF — Receiver Noise Flag Bit
This clearable, read-only bit is set when the ESCI detects noise on the RxD pin.
NF generates an NF CPU interrupt request if the NEIE bit in SCC3 is also set.
Clear the NF bit by reading SCS1 and then reading the SCDR. Reset clears the
NF bit.
1 = Noise detected
0 = No noise detected
NORMAL FLAG CLEARING SEQUENCE
BYTE 1
READ SCS1
SCRF = 1
OR = 0
READ SCDR
BYTE 1
BYTE 2
READ SCS1
SCRF = 1
OR = 0
READ SCDR
BYTE 2
BYTE 3
READ SCS1
SCRF = 1
OR = 0
READ SCDR
BYTE 3
BYTE 4
DELAYED FLAG CLEARING SEQUENCE
BYTE 1
BYTE 2
BYTE 3
READ SCS1
SCRF = 1
OR = 0
READ SCS1
SCRF = 1
OR = 1
READ SCDR
BYTE 1
READ SCDR
BYTE 3
Figure 14-14. Flag Clearing Sequence
BYTE 4
FE — Receiver Framing Error Bit
This clearable, read-only bit is set when a logic 0 is accepted as the stop bit. FE
generates an ESCI error CPU interrupt request if the FEIE bit in SCC3 also is
set. Clear the FE bit by reading SCS1 with FE set and then reading the SCDR.
Reset clears the FE bit.
1 = Framing error detected
0 = No framing error detected
PE — Receiver Parity Error Bit
This clearable, read-only bit is set when the ESCI detects a parity error in
incoming data. PE generates a PE CPU interrupt request if the PEIE bit in SCC3
MC68HC908GR16 — Rev. 1.0
MOTOROLA
Enhanced Serial Communications Interface (ESCI) Module
For More Information On This Product,
Go to: www.freescale.com
Data Sheet
183