MC68HC908GR16 Datasheet, PDF (175/310 Pages) Motorola, Inc – Microcontrollers

Freescale Semiconductor, Inc.
Enhanced Serial Communications Interface (ESCI) Module
I/O Signals
the break, the bit cannot change during the break state as long as BCFE is at
logic 0. After the break, doing the second step clears the status bit.
14.7 I/O Signals
Port E shares two of its pins with the ESCI module. The two ESCI I/O pins are:
• PTE0/TxD — transmit data
• PTE1/RxD — receive data
14.7.1 PTE0/TxD (Transmit Data)
The PTE0/TxD pin is the serial data output from the ESCI transmitter. The ESCI
shares the PTE0/TxD pin with port E. When the ESCI is enabled, the PTE0/TxD
pin is an output regardless of the state of the DDRE0 bit in data direction register
E (DDRE).
14.7.2 PTE1/RxD (Receive Data)
The PTE1/RxD pin is the serial data input to the ESCI receiver. The ESCI shares
the PTE1/RxD pin with port E. When the ESCI is enabled, the PTE1/RxD pin is an
input regardless of the state of the DDRE1 bit in data direction register E (DDRE).
14.8 I/O Registers
These I/O registers control and monitor ESCI operation:
• ESCI control register 1, SCC1
• ESCI control register 2, SCC2
:
• ESCI control register 3, SCC3
• ESCI status register 1, SCS1
• ESCI status register 2, SCS2
• ESCI data register, SCDR
• ESCI baud rate register, SCBR
• ESCI prescaler register, SCPSC
• ESCI arbiter control register, SCIACTL
• ESCI arbiter data register, SCIADAT
MC68HC908GR16 — Rev. 1.0
MOTOROLA
Enhanced Serial Communications Interface (ESCI) Module
For More Information On This Product,
Go to: www.freescale.com
Data Sheet
175