MC68HC908MR8 Datasheet, PDF (168/372 Pages) Motorola, Inc – Microcontrollers

Pulse-Width Modulator for Motor Control
The function of the fault control and event bits is the same as in
automatic mode except that the PWMs are not re-enabled until the
FFLAGx event bit is cleared by writing to the FTACKx bit and the filtered
fault condition is cleared (logic low).
9.7.2 Software Output Disable
Setting PWM disable bit DISX or DISY in PWM control register 1
immediately disables the corresponding PWM pins as determined by the
bank and disable mapping register. The PWM pin(s) remain disabled
until the PWM disable bit is cleared and a new PWM cycle begins as
shown in Figure 9-27. Setting a PWM disable bit does not latch a CPU
interrupt request, and there are no event flags associated with the PWM
disable bits.
9.7.3 Output Port Control
When operating the PWMs using the OUTx bits (OUTCTL = 1), fault
protection applies as described in this section. Due to the absence of
periodic PWM cycles, fault conditions are cleared upon each CPU cycle
and the PWM outputs are re-enabled, provided all fault clearing
conditions are satisfied.
DISABLE BIT
PWM(S) ENABLED
PWM(S) DISABLED
PWM(S) ENABLED
Figure 9-27. PWM Software Disable
Technical Data
168
MC68HC908MR8 — Rev 4.1
Pulse-Width Modulator for Motor Control (PWMMC) Freescale Semiconductor