UPD78F9500MA-CAC-A Datasheet, PDF (316/342 Pages) Renesas Technology Corp – 8-Bit Single-Chip Microcontrollers

APPENDIX A DEVELOPMENT TOOLS
A.3 Flash Memory Writing Tools
A.3.1 When using flash memory programmer PG-FP5 and FL-PR5
FL-PR5, PG-FP5
Flash memory programmer
FA-78F9202MA-CAC-RX
Flash memory writing adapter
This is a flash memory programmer dedicated to microcontrollers incorporating a flash
memory.
This is a flash memory writing adapter which is used in connection with the flash
memory programmer.
Remarks 1. FL-PR5 and FA-78F9202MA-CAC-RX are products of Naito Densei Machida Mfg. Co., Ltd
(http://www.ndk-m.co.jp/, e-mail: [e-mail]).
2. Use the latest version of the flash memory programming adapter.
A.3.2 When using on-chip debug emulator with programming function QB-MINI2
QB-MINI2
On-chip debug emulator with
programming function
Target connector specifications
This is a flash memory programmer dedicated to microcontrollers with on-chip flash
memory. It is available also as on-chip debug emulator which serves to debug hardware
and software when developing application systems using the 78K0S/Kx1+
microcontrollers. When using this as flash memory programmer, it should be used in
combination with a connection cable and a USB interface cable that is used to connect
the host machine.
16-pin general-purpose connector (2.54 mm pitch)
Remark Download the software for operating the QB-MINI2 from the download site for development tools
(http://www.necel.com/micro/en/ods/).
A.4 Debugging Tools (Hardware)
A.4.1 When using in-circuit emulator QB-78K0SKX1
QB-78K0SKX1
In-circuit emulator
QB-50-EP-01T^Note
Emulation probe
QB-10MA-EA-01T^Note
Exchange adapter
QB-10MA-NQ-01T^Note
Target connector
Specifications of pin header on
target system
This in-circuit emulator serves to debug hardware and software when developing application
systems using the 78K0S/Kx1+ microcontrollers. It supports the integrated debugger
(ID78K0S-QB). This emulator should be used in combination with a power supply unit and
emulation probe, and the USB is used to connect this emulator to the host machine.
This is a flexible type emulation probe and is used to connect the in-circuit emulator and target
system.
This exchange adapter is used to perform pin conversion from the in-circuit emulator to target
connector.
This target connector is used to mount on the target system.
0.635 mm × 0.635 mm (height: 6 mm)
(Note and Remarks are listed on the next page or later.)
314
User’s Manual U18172EJ3V0UD