UPD78F9500MA-CAC-A Datasheet, PDF (302/342 Pages) Renesas Technology Corp – 8-Bit Single-Chip Microcontrollers

CHAPTER 19 ELECTRICAL SPECIFICATIONS
DC Characteristics (4/4)
<R> (2) μPD78F950x (TA = −40 to +85°C, VDD = 2.0 to 5.5 V^{Note 1}, VSS = 0 V) (2/2)
Parameter
Supply
current^{Note 2}
Symbol
I ^{Note 3}
DD1
External clock
input oscillation
operating
mode^{Note 6}
IDD2
External clock
input HALT
mode^{Note 6}
Conditions
MIN. TYP. MAX. Unit
fX = 10 MHz
VDD = 5.0 V ±10%^{Note 4}
6.1 12.2 mA
fX = 6 MHz
VDD = 5.0 V ±10%^{Note 4}
5.5 11.0 mA
fX = 5 MHz
VDD = 3.0 V ±10%^{Note 5}
3.0 6.0 mA
fX = 10 MHz
VDD = 5.0 V ±10%^{Note 4}
When peripheral functions are stopped
When peripheral functions are operating
1.7 3.8 mA
6.7
fX = 6 MHz
VDD = 5.0 V ±10%^{Note 4}
When peripheral functions are stopped
When peripheral functions are operating
1.3 3.0 mA
6.0
I ^{Note 3}
DD3
fX = 5 MHz
VDD = 3.0 V ±10%^{Note 5}
High-speed
internal oscillation
operating
mode^{Note 7}
fX = 8 MHz
VDD = 5.0 V ±10%^{Note 4}
When peripheral functions are stopped
When peripheral functions are operating
0.48 1 mA
2.1
5.0 10.0 mA
IDD4
High-speed
fX = 8 MHz
When peripheral functions are stopped
internal oscillation VDD = 5.0 V ±10%^{Note 4}
HALT mode^{Note 7}
When peripheral functions are operating
IDD5
STOP mode
VDD = 5.0 V ±10%
When low-speed internal oscillation is
stopped
1.4 3.2 mA
5.9
3.5 20.0 μA
VDD = 3.0 V ±10%
When low-speed internal oscillation is
operating
When low-speed internal oscillation is
stopped
17.5 32.0
3.5 15.5 μA
When low-speed internal oscillation is
operating
11.0 26.0
Notes 1.
2.
3.
4.
5.
6.
7.
Use this product in a voltage range of 2.2 to 5.5 V because the detection voltage (VPOC) of the power-on
clear (POC) circuit is 2.1 V ±0.1 V.
Total current flowing through the internal power supply (VDD). However, the current that flows through the
pull-up resistors of ports is not included.
IDD1 and IDD3 include peripheral operation current.
When the processor clock control register (PCC) is set to 00H.
When the processor clock control register (PCC) is set to 02H.
When external clock input is selected as the system clock source using the option byte.
When high-speed internal oscillation clock is selected as the system clock source using the option byte.
300
User’s Manual U18172EJ3V0UD