UPD78F9500MA-CAC-A Datasheet, PDF (283/342 Pages) Renesas Technology Corp – 8-Bit Single-Chip Microcontrollers

CHAPTER 17 ON-CHIP DEBUG FUNCTION
Notes 2. This is the pin connection when the X1 and X2 pins are not used in the target system. When using
the X1 and X2 pins, refer to 17.1.2 Connection of X1 and X2 pins.
3. No problem will occur if the dashed line portions are connected.
4. This pin is connected to enhance the accuracy of time measurement between run and break during
debugging. Debugging is possible even if this pin is left open, but measurement error occurs in
several ms units.
5. The INTP1 pin is used for communication between QB-MINI2 and the target device during
debugging. When debugging is performed with QB-MINI2, therefore, the INTP1 pin and its
alternate-function pin cannot be used. For INTP1 pin connection, refer to 17.1.1 Connection of
INTP1 pin.
Pins for communication depend on whether the monitor program has been written or not. (refer to Table 17-1)
X1 and X2 pins can be used as I/O port pins or the pins for oscillation, after the monitor program has been written.
Table 17-1. Pins for communication with QB-MINI2
Before writing the monitor program
X1^{Note 1}, X2 ^{Note 2}, RESET, INTP1, VDD, VSS
After writing the monitor program
RESET, INTP1, VDD, VSS
<R>
Notes 1. μPD78F920x: X1/P23/ANI3, μPD78F950x: EXCLK/P23
<R>
2. μPD78F920x: X2/P22/ANI2, μPD78F950x: P22
17.1.1 Connection of INTP1 pin
The INTP1 pin is used only for communication between QB-MINI2 and the target device during debugging.
Design circuits appropriately according to the relevant case among the cases shown below.
(1) INTP1 pin is not used in target system (as is illustrated in Figure 17-1. Recommended Circuit
Connection)
→ See Figure 17-2.
(2) QB-MINI2 is used only for programming, not for debugging
→ See Figure 17-3.
(3) QB-MINI2 is used for debugging and debugging of the INTP1 pin is performed only with a real machine
→ See Figure 17-4.
Figure 17-2. Circuit Connection for the Case Where INTP1 Pin Is Not Used in Target System
VDD
Target connector
12
INTP
1 kΩ
Target device
INTP1
Figure 17-3. Circuit Connection for the Case Where QB-MINI2 Is Used Only for Programming
Target connector
Target device
12
INTP
INTP1
User’s Manual U18172EJ3V0UD
281