English
Language : 

UPD78F9500MA-CAC-A Datasheet, PDF (255/342 Pages) Renesas Technology Corp – 8-Bit Single-Chip Microcontrollers
CHAPTER 16 FLASH MEMORY
16.8.7 Example of block blank check operation in self programming mode
An example of the block blank check operation in self programming mode is explained below.
<1> Set 04H (block blank check) to the flash program command register (FLCMD).
<2> Set the number of block for which a blank check is performed, to flash address pointer H (FLAPH).
<3> Set flash address pointer L (FLAPL) to 00H.
<4> Write the same value as FLAPH to the flash address pointer H compare register (FLAPHC).
<5> Set the flash address pointer L compare register (FLAPLC) to FFH.
<6> Clear the flash status register (PFS).
<7> Write ACH to the watchdog timer enable register (WDTE) (clear and restart the watchdog timer counter)Note.
<8> Execute the HALT instruction then start self programming. (Execute an instruction immediately after the
HALT instruction if self programming has been executed.)
<9> Check if a self programming error has occurred using bit 1 (VCERR) and bit 2 (WEPRERR) of PFS.
Abnormal → <10>
Normal → <11>
<10> Block blank check is abnormally terminated.
<11> Block blank check is normally terminated.
Note This setting is not required when the watchdog timer is not used.
User’s Manual U18172EJ3V0UD
253