UPD78F9500MA-CAC-A Datasheet, PDF (123/342 Pages) Renesas Technology Corp – 8-Bit Single-Chip Microcontrollers

CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00 (μPD78F920x ONLY)
Figure 6-34. Timing of One-Shot Pulse Output Operation with Software Trigger
Set TMC00 to 04H
(TM00 count starts)
Count clock
TM00 count 0000H 0001H
N N + 1 0000H
N−1 N
M−1 M M+1 M+2
CR010 set value
N
N
N
N
CR000 set value
M
M
M
M
OSPT00
INTTM010
INTTM000
TO00 pin output
Caution 16-bit timer counter 00 starts operating as soon as a value other than 00 (operation stop
mode) is set to the TMC003 and TMC002 bits.
Remark N < M
(2) One-shot pulse output with external trigger
A one-shot pulse can be output from the TO00 pin by setting 16-bit timer mode control register 00 (TMC00),
capture/compare control register 00 (CRC00), and 16-bit timer output control register 00 (TOC00) as shown in
Figure 6-35, and by using the valid edge of the TI000 pin as an external trigger.
The valid edge of the TI000 pin is specified by bits 4 and 5 (ES000, ES010) of prescaler mode register 00
(PRM00). The rising, falling, or both the rising and falling edges can be specified.
When the valid edge of the TI000 pin is detected, the 16-bit timer/event counter is cleared and started, and the
output becomes active at the count value set in advance to 16-bit timer capture/compare register 010
(CR010). After that, the output becomes inactive at the count value set in advance to 16-bit timer
capture/compare register 000 (CR000)^Note.
Note The case where N < M is described here. When N > M, the output becomes active with the CR000
register and inactive with the CR010 register. Do not set N to M.
Caution Do not input the external trigger again while the one-shot pulse is output.
To output the one-shot pulse again, wait until the current one-shot pulse output is
completed.
User’s Manual U18172EJ3V0UD
121