M16C30P_07 Datasheet, PDF (191/317 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/30 SERIES

M16C/30P Group
16. A/D Converter
16.1.2 Repeat Mode
In repeat mode, analog voltage applied to a selected pin is repeatedly converted to a digital code. Table 16.3
shows the Repeat Mode Specifications. Figures 16.6 and 16.7 shows the ADCON0 to ADCON1 registers in
repeat mode.
Table 16.3 Repeat Mode Specifications
Item
Specification
Function
The CH2 to CH0 bits in the ADCON0 register, the ADGSEL1 to ADGSEL0 bits
in the ADCON2 register and the OPA1 to OPA0 bits in the ADCON1 register
select a pin. Analog voltage applied to this pin is repeatedly converted to a
digital code.
A/D Conversion Start
Condition
• When the TRG bit in the ADCON0 register is “0” (software trigger)
The ADST bit in the ADCON0 register is set to “1” (A/D conversion starts)
• When the TRG bit is “1” (ADTRG trigger)
Input on the ADTRG pin changes state from high to low after the ADST bit is
set to “1” (A/D conversion starts)
A/D Conversion Stop
Condition
Set the ADST bit to “0” (A/D conversion halted)
Interrupt Request
Generation timing
None generated
Analog Input Pin
Select one pin from AN0 to AN7, AN0_0 to AN0_7, ANEX0 to ANEX1
Reading of Result of A/D Read one of the AD0 to AD7 registers that corresponds to the selected pin
Converter
Rev.1.22 Mar 29, 2007 Page 175 of 291
REJ09B0179-0122