PIC18F87K22 Datasheet, PDF (258/548 Pages) Microchip Technology – 64/80-Pin, High-Performance, 1-Mbit Enhanced Flash Microcontrollers with 12-Bit A/D and nanoWatt XLP Technology

PIC18F87K22 FAMILY
REGISTER 20-1: CCPxCON: ENHANCED CAPTURE/COMPARE/PWM x CONTROL
R/W-0
PxM1
bit 7
R/W-0
PxM0
R/W-0
DCxB1
R/W-0
DCxB0
R/W-0
CCPxM3
R/W-0
CCPxM2
R/W-0
CCPxM1
R/W-0
CCPxM0
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 7-6
bit 5-4
bit 3-0
PxM<1:0>: Enhanced PWM Output Configuration bits
If CCPxM<3:2> = 00, 01, 10:
xx = PxA assigned as capture/compare input/output; PxB, PxC and PxD assigned as port pins
If CCPxM<3:2> = 11:
00 = Single output: PxA, PxB, PxC and PxD are controlled by steering (see Section 20.4.7 “Pulse
Steering Mode”)
01 = Full-bridge output forward: PxD is modulated; PxA is active; PxB, PxC is inactive
10 = Half-bridge output: PxA, PxB are modulated with dead-band control; PxC and PxD are
assigned as port pins
11 = Full-bridge output reverse: PxB is modulated; PxC is active; PxA and PxD are inactive
DCxB<1:0>: PWM Duty Cycle bit 1 and bit 0
Capture mode:
Unused.
Compare mode:
Unused.
PWM mode:
These bits are the two LSbs of the 10-bit PWM duty cycle. The eight MSbs of the duty cycle are found
in CCPRxL.
CCPxM<3:0>: ECCPx Mode Select bits
0000 = Capture/Compare/PWM off (resets ECCPx module)
0001 = Reserved
0010 = Compare mode: toggle output on match
0011 = Capture mode
0100 = Capture mode: every falling edge
0101 = Capture mode: every rising edge
0110 = Capture mode: every fourth rising edge
0111 = Capture mode: every 16^th rising edge
1000 = Compare mode: initialize ECCPx pin low, set output on compare match (set CCPxIF)
1001 = Compare mode: initialize ECCPx pin high, clear output on compare match (set CCPxIF)
1010 = Compare mode: generate software interrupt only, ECCPx pin reverts to I/O state
1011 = Compare mode: trigger special event (ECCPx resets TMR1 or TMR3, starts A/D conversion,
sets CCPxIF bit)
1100 = PWM mode: PxA and PxC are active-high; PxB and PxD are active-high
1101 = PWM mode: PxA and PxC are active-high; PxB and PxD are active-low
1110 = PWM mode: PxA and PxC are active-low; PxB and PxD are active-high
1111 = PWM mode: PxA and PxC are active-low; PxB and PxD are active-low
DS39960B-page 258
Preliminary
 2010 Microchip Technology Inc.