301467-005 Datasheet, PDF (81/426 Pages) Intel Corporation – Express Chipset

Host Bridge/DRAM Controller Registers (D0:F0)
R
4.1.18
PAM0—Programmable Attribute Map 0 (D0:F0)
PCI Device:
Address Offset:
Default Value:
Access:
Size:
0
90h
00h
R/W
8 bits
This register controls the read, write, and shadowing attributes of the BIOS area from 0F0000h–
0FFFFFh
The (G)MCH allows programmable memory attributes on 13 Legacy memory segments of
various sizes in the 768-KB to 1-MB address range. Seven Programmable Attribute Map (PAM)
Registers are used to support these features. Cache ability of these areas is controlled via the
MTRR registers in the processor. Two bits are used to specify memory attributes for each
memory segment. These bits apply to both host accesses and PCI initiator accesses to the PAM
areas. These attributes are:
• RE (Read Enable). When RE = 1, the processor read accesses to the corresponding memory
segment are claimed by the (G)MCH and directed to main memory. Conversely, when
RE = 0, the host read accesses are directed to Primary PCI.
• WE (Write Enable). When WE = 1, the host write accesses to the corresponding memory
segment are claimed by the (G)MCH and directed to main memory. Conversely, when
WE = 0, the host write accesses are directed to Primary PCI.
The RE and WE attributes permit a memory segment to be Read Only, Write Only, Read/Write,
or disabled. For example, if a memory segment has RE = 1 and WE = 0, the segment is Read
Only.
Each PAM Register controls two regions, typically 16 KB in size.
Bit Access &
Default
Description
7:6
Reserved
5:4
R/W
0F0000-0FFFFF Attribute (HIENABLE): This field controls the steering of read and
00b
write cycles that addresses the BIOS area from 0F0000h to 0FFFFFh.
00 = DRAM Disabled: All accesses are directed to the DMI.
01 = Read Only: All reads are sent to DRAM. All writes are forwarded to the DMI.
10 = Write Only: All writes are sent to DRAM. Reads are serviced by DMI.
11 = Normal DRAM Operation: All reads and writes are serviced by DRAM.
3:0
Reserved
Warning: The (G)MCH may hang if a PCI Express graphics attach or DMI originated access to Read
Disabled or Write Disabled PAM segments occurs (due to a possible IWB to non-DRAM). For
these reasons the following critical restriction is placed on the programming of the PAM regions:
At the time that a DMI or PCI Express graphics attach accesses to the PAM region may occur, the
targeted PAM segment must be programmed to be both readable and writeable.
Datasheet
81