MC68HC08AZ32A Datasheet, PDF (307/312 Pages) Motorola, Inc – HCMOS Microcontroller Unit

serial peripheral interface module (SPI) — A module in the M68HC08 Family that supports
synchronous communication.
set — To change a bit from logic 0 to logic 1; opposite of clear.
shift register — A chain of circuits that can retain the logic levels (logic 1 or logic 0) written to them and
that can shift the logic levels to the right or left through adjacent circuits in the chain.
signed — A binary number notation that accommodates both positive and negative numbers. The most
significant bit is used to indicate whether the number is positive or negative, normally logic 0 for
positive and logic 1 for negative. The other seven bits indicate the magnitude of the number.
software — Instructions and data that control the operation of a microcontroller.
software interrupt (SWI) — An instruction that causes an interrupt and its associated vector fetch.
SPI — See "serial peripheral interface module (SPI)."
stack — A portion of RAM reserved for storage of CPU register contents and subroutine return
addresses.
stack pointer (SP) — A 16-bit register in the CPU08 containing the address of the next available storage
location on the stack.
start bit — A bit that signals the beginning of an asynchronous serial transmission.
status bit — A register bit that indicates the condition of a device.
stop bit — A bit that signals the end of an asynchronous serial transmission.
subroutine — A sequence of instructions to be used more than once in the course of a program. The last
instruction in a subroutine is a return from subroutine (RTS) instruction. At each place in the main
program where the subroutine instructions are needed, a jump or branch to subroutine (JSR or BSR)
instruction is used to call the subroutine. The CPU leaves the flow of the main program to execute the
instructions in the subroutine. When the RTS instruction is executed, the CPU returns to the main
program where it left off.
synchronous — Refers to logic circuits and operations that are synchronized by a common reference
signal.
TIM — See "timer interface module (TIM)."
timer interface module (TIM) — A module used to relate events in a system to a point in time.
timer — A module used to relate events in a system to a point in time.
toggle — To change the state of an output from a logic 0 to a logic 1 or from a logic 1 to a logic 0.
tracking mode — Mode of low-jitter PLL operation during which the PLL is locked on a frequency. Also
see "acquisition mode."
two’s complement — A means of performing binary subtraction using addition techniques. The most
significant bit of a two’s complement number indicates the sign of the number (1 indicates negative).
The two’s complement negative of a number is obtained by inverting each bit in the number and then
adding 1 to the result.
unbuffered — Utilizes only one register for data; new data overwrites current data.
unimplemented memory location — A memory location that is not used. Writing to an unimplemented
location has no effect. Reading an unimplemented location returns an unpredictable value. Executing
an opcode at an unimplemented location causes an illegal address reset.
MC68HC08AZ32A Data Sheet, Rev. 2
Freescale Semiconductor
307