English
Language : 

MC68HC08AZ32A Datasheet, PDF (247/312 Pages) Motorola, Inc – HCMOS Microcontroller Unit
I/O Registers
Address: $0020
Bit 7
6
5
4
3
2
1
Bit 0
Read: TOF
0
0
TOIE TSTOP
Write: 0
TRST
R
PS2
PS1
PS0
Reset: 0
0
1
0
0
0
0
0
R
= Reserved
Figure 17-5. TIMA Status and Control Register (TASC)
TOF — TIMA Overflow Flag Bit
This read/write flag is set when the TIMA counter reaches the modulo value programmed in the TIMA
counter modulo registers. Clear TOF by reading the TIMA status and control register when TOF is set
and then writing a 0 to TOF. If another TIMA overflow occurs before the clearing sequence is complete,
then writing a 0 to TOF has no effect. Therefore, a TOF interrupt request cannot be lost due to
inadvertent clearing of TOF. Reset clears the TOF bit. Writing a 1 to TOF has no effect.
1 = TIMA counter has reached modulo value.
0 = TIMA counter has not reached modulo value.
TOIE — TIMA Overflow Interrupt Enable Bit
This read/write bit enables TIMA overflow interrupts when the TOF bit becomes set. Reset clears the
TOIE bit.
1 = TIMA overflow interrupts enabled
0 = TIMA overflow interrupts disabled
TSTOP — TIMA Stop Bit
This read/write bit stops the TIMA counter. Counting resumes when TSTOP is cleared. Reset sets the
TSTOP bit, stopping the TIMA counter until software clears the TSTOP bit.
1 = TIMA counter stopped
0 = TIMA counter active
NOTE
Do not set the TSTOP bit before entering wait mode if the TIMA is required
to exit wait mode. Also, when the TSTOP bit is set and input capture mode
is enabled, input captures are inhibited until TSTOP is cleared.
When using TSTOP to stop the timer counter, see if any timer flags are set.
If a timer flag is set, it must be cleared by clearing TSTOP, then clearing the
flag, then setting TSTOP again.
TRST — TIMA Reset Bit
Setting this write-only bit resets the TIMA counter and the TIMA prescaler. Setting TRST has no effect
on any other registers. Counting resumes from $0000. TRST is cleared automatically after the TIMA
counter is reset and always reads as 0. Reset clears the TRST bit.
1 = Prescaler and TIMA counter cleared
0 = No effect
NOTE
Setting the TSTOP and TRST bits simultaneously stops the TIMA counter
at a value of $0000.
MC68HC08AZ32A Data Sheet, Rev. 2
Freescale Semiconductor
247