MC68HC08AZ32A Datasheet, PDF (269/312 Pages) Motorola, Inc – HCMOS Microcontroller Unit

I/O Registers
MSxB — Mode Select Bit B
This read/write bit selects buffered output compare/PWM operation. MSxB exists only in the TIMB
channel 0.
Setting MS0B disables the channel 1 status and control register and reverts TBCH1 to
general-purpose I/O.
Reset clears the MSxB bit.
1 = Buffered output compare/PWM operation enabled
0 = Buffered output compare/PWM operation disabled
MSxA — Mode Select Bit A
When ELSxB:A ≠ 00, this read/write bit selects either input capture operation or unbuffered output
compare/PWM operation (see Table 18-2).
1 = Unbuffered output compare/PWM operation
0 = Input capture operation
When ELSxB:A = 00, this read/write bit selects the initial output level of the TBCHx pin once PWM,
input capture or output compare operation is enabled (see Table 18-2). Reset clears the MSxA bit.
1 = Initial output level low
0 = Initial output level high
NOTE
Before changing a channel function by writing to the MSxB or MSxA bit, set
the TSTOP and TRST bits in the TIMB status and control register (TBSC).
ELSxB and ELSxA — Edge/Level Select Bits
When channel x is an input capture channel, these read/write bits control the active edge-sensing logic
on channel x.
When channel x is an output compare channel, ELSxB and ELSxA control the channel x output
behavior when an output compare occurs.
When ELSxB and ELSxA are both clear, channel x is not connected to port F and pin PTFx/TBCHx is
available as a general-purpose I/O pin. However, channel x is at a state determined by these bits and
becomes transparent to the respective pin when PWM, input capture, or output compare mode is
enabled. Table 18-2 shows how ELSxB and ELSxA work. Reset clears the ELSxB and ELSxA bits.
NOTE
Before enabling a TIMB channel register for input capture operation, make
sure that the PTFx/TBCHx pin is stable for at least two bus clocks.
TOVx — Toggle-On-Overflow Bit
When channel x is an output compare channel, this read/write bit controls the behavior of the channel x
output when the TIMB counter overflows. When channel x is an input capture channel, TOVx has no
effect. Reset clears the TOVx bit.
1 = Channel x pin toggles on TIMB counter overflow.
0 = Channel x pin does not toggle on TIMB counter overflow.
NOTE
When TOVx is set, a TIMB counter overflow takes precedence over a
channel x output compare if both occur at the same time.
MC68HC08AZ32A Data Sheet, Rev. 2
Freescale Semiconductor
269