PIC18F6X2X Datasheet, PDF (50/386 Pages) Microchip Technology – 64/80-Pin High Performance, 64-Kbyte Enhanced FLASH Microcontrollers with A/D

PIC18F6X2X/8X2X
4.7.1 TWO-WORD INSTRUCTIONS
The PIC18F6X2X/8X2X devices have four two-word
instructions: MOVFF, CALL, GOTO and LFSR. The
second word of these instructions has the 4 MSBs set
to ‘1’s and is a special kind of NOP instruction. The
lower 12 bits of the second word contain data to be
used by the instruction. If the first word of the instruc-
tion is executed, the data in the second word is
accessed. If the second word of the instruction is exe-
cuted by itself (first word was skipped), it will execute as
a NOP. This action is necessary when the two-word
instruction is preceded by a conditional instruction that
changes the PC. A program example that demon-
strates this concept is shown in Example 4-3. Refer to
Section 25.0 for further details of the instruction set.
EXAMPLE 4-3:
CASE 1:
TWO-WORD INSTRUCTIONS
Object Code
Source Code
0110 0110 0000 0000
1100 0001 0010 0011
1111 0100 0101 0110
0010 0100 0000 0000
TSTFSZ
MOVFF
ADDWF
REG1
; is RAM location 0?
REG1, REG2 ; No, execute 2-word instruction
; 2nd operand holds address of REG2
REG3
; continue code
CASE 2:
Object Code
Source Code
0110 0110 0000 0000
1100 0001 0010 0011
1111 0100 0101 0110
0010 0100 0000 0000
TSTFSZ
MOVFF
ADDWF
REG1
; is RAM location 0?
REG1, REG2 ; Yes
; 2nd operand becomes NOP
REG3
; continue code
4.8 Lookup Tables
Lookup tables are implemented two ways. These are:
• Computed GOTO
• Table Reads
4.8.1 COMPUTED GOTO
A computed GOTO is accomplished by adding an offset
to the program counter (ADDWF PCL).
A lookup table can be formed with an ADDWF PCL
instruction and a group of RETLW 0xnn instructions.
WREG is loaded with an offset into the table before
executing a call to that table. The first instruction of the
called routine is the ADDWF PCL instruction. The next
instruction executed will be one of the RETLW 0xnn
instructions that returns the value 0xnn to the calling
function.
The offset value (value in WREG) specifies the number
of bytes that the program counter should advance.
In this method, only one data byte may be stored in
each instruction location and room on the return
address stack is required.
4.8.2 TABLE READS/TABLE WRITES
A better method of storing data in program memory
allows 2 bytes of data to be stored in each instruction
location.
Lookup table data may be stored 2 bytes per program
word by using table reads and writes. The table pointer
(TBLPTR) specifies the byte address and the table
latch (TABLAT) contains the data that is read from, or
written to program memory. Data is transferred to/from
program memory, one byte at a time.
A description of the table read/table write operation is
shown in Section 5.0.
DS39612A-page 48
Advance Information
 2003 Microchip Technology Inc.