PIC18F6X2X Datasheet, PDF (3/386 Pages) Microchip Technology – 64/80-Pin High Performance, 64-Kbyte Enhanced FLASH Microcontrollers with A/D

PIC18F6X2X/8X2X
64/80-Pin High Performance, 64-Kbyte Enhanced FLASH
Microcontrollers with A/D
High Performance RISC CPU:
• Linear program memory addressing to 64 Kbytes
• Linear data memory addressing to 4 Kbytes
• 1 Kbyte of data EEPROM
• Up to 10 MIPs operation:
- DC - 40 MHz osc./clock input
- 4 MHz - 10 MHz osc./clock input with PLL active
• 16-bit wide instructions, 8-bit wide data path
• Priority levels for interrupts
• 31-level, software accessible hardware stack
• 8 x 8 Single Cycle Hardware Multiplier
Peripheral Features:
• High current sink/source 25 mA/25 mA
• Four external interrupt pins
• Timer0 module: 8-bit/16-bit timer/counter
• Timer1 module: 16-bit timer/counter
• Timer2 module: 8-bit timer/counter
• Timer3 module: 16-bit timer/counter
• Timer4 module: 8-bit timer/counter
• Secondary oscillator clock option - Timer1/Timer3
• Two Capture/Compare/PWM (CCP) modules:
- Capture is 16-bit, max. resolution 6.25 ns (TCY/16)
- Compare is 16-bit, max. resolution 100 ns (TCY)
- PWM output: PWM resolution is 1 to 10-bit
• Three Enhanced Capture/Compare/PWM (ECCP)
modules:
- Same Capture/Compare features as CCP
- One, two, or four PWM outputs
- Selectable polarity
- Programmable dead-time
- Auto shutdown on external event
- Auto Restart
• Master Synchronous Serial Port (MSSP) module
with two modes of operation:
- 3-wire SPI™ (supports all 4 SPI modes)
- I²C™ Master and Slave mode
• Two Enhanced USART modules:
- Supports RS-485, RS-232, and LIN 1.2
- Auto wake-up on START bit
- Auto baud detect
• Parallel Slave Port (PSP) module
External Memory Interface
(PIC18F8X2X Devices Only):
• Address capability of up to 2 Mbytes
• 16-bit interface
Analog Features:
• 10-bit, up to 16-channel Analog-to-Digital
Converter (A/D):
- Auto acquisition
- Conversion available during SLEEP
• Programmable 16-level Low Voltage Detection
(LVD) module:
- Supports interrupt on Low Voltage Detection
• Programmable Brown-out Reset (BOR)
• Dual analog comparators:
- Programmable input/output configuration
Special Microcontroller Features:
• 100,000 erase/write cycle Enhanced FLASH
program memory typical
• 1,000,000 erase/write cycle Data EEPROM
memory typical
• 1 second programming time
• FLASH/Data EEPROM Retention: > 100 years
• Self-reprogrammable under software control
• Power-on Reset (POR), Power-up Timer (PWRT)
and Oscillator Start-up Timer (OST)
• Watchdog Timer (WDT) with its own On-Chip
RC Oscillator for reliable operation
• Programmable code protection
• Power saving SLEEP mode
• Selectable oscillator options including:
- 4X Phase Lock Loop (of primary oscillator)
- Secondary Oscillator (32 kHz) clock input
• In-Circuit Serial Programming™ (ICSP™) via two pins
• MPLAB^® In-Circuit Debug (ICD 2) via two pins
CMOS Technology:
• Low power, high speed FLASH technology
• Fully static design
• Wide operating voltage range (2.0V to 5.5V)
• Industrial and Extended temperature ranges
Program Memory Data Memory
Device
Bytes
# Single
Word
Instructions
SRAM EEPROM
(bytes) (bytes)
I/O
PIC18F6525 48K
24576
3840 1024 53
PIC18F6621 64K
32768
3840 1024 53
PIC18F8525 48K
24576
3840 1024 69
PIC18F8621 64K
32768
3840 1024 69
10-bit
A/D
(ch)
CCP/
ECCP
MSSP/
PWM SPI/ EUSART
Master I²C
Timers
8-bit/16-bit
EMI
12 2/3 14
Y
2
2/3
N
12 2/3 14
Y
2
2/3
N
16 2/3 14
Y
2
2/3
Y
16 2/3 14
Y
2
2/3
Y
 2003 Microchip Technology Inc.
Advance Information
DS39612A-page 1