PIC18F6X2X Datasheet, PDF (335/386 Pages) Microchip Technology – 64/80-Pin High Performance, 64-Kbyte Enhanced FLASH Microcontrollers with A/D

PIC18F6X2X/8X2X
27.3 DC Characteristics: PIC18F6X2X/8X2X (Industrial, Extended)
PIC18LF6X2X/8X2X (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ TA ≤ +125°C for extended
Param
No.
Symbol
Characteristic
Min
Max Units
Conditions
VOL Output Low Voltage
D080
D080A
D083
D083A
VOH
D090
D090A
D092
I/O ports
OSC2/CLKO
(RC mode)
Output High Voltage⁽³⁾
I/O ports
OSC2/CLKO
(RC mode)
—
0.6
—
0.6
—
0.6
—
0.6
VDD – 0.7
—
VDD – 0.7
—
VDD – 0.7
—
V IOL = 8.5 mA, VDD = 4.5V,
-40°C to +85°C
V IOL = 7.0 mA, VDD = 4.5V,
-40°C to +125°C
V IOL = 1.6 mA, VDD = 4.5V,
-40°C to +85°C
V IOL = 1.2 mA, VDD = 4.5V,
-40°C to +125°C
V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
V IOH = -2.5 mA, VDD = 4.5V,
-40°C to +125°C
V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
D092A
D150 VOD
Open Drain High Voltage
VDD – 0.7
—
—
8.5
V IOH = -1.0 mA, VDD = 4.5V,
-40°C to +125°C
V RA4 pin
D100^{(4) COSC2}
Capacitive Loading Specs
on Output Pins
OSC2 pin
—
15
pF In XT, HS and LP modes
when external clock is used
to drive OSC1
D101 CIO
D102 CB
All I/O pins and OSC2
(in RC mode)
SCL, SDA
—
50
pF To meet the AC Timing
Specifications
—
400
pF In I²C mode
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PICmicro device be driven with an external clock while in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: Parameter is characterized but not tested.
 2003 Microchip Technology Inc.
Advance Information
DS39612A-page 333