PIC18F6X2X Datasheet, PDF (257/386 Pages) Microchip Technology – 64/80-Pin High Performance, 64-Kbyte Enhanced FLASH Microcontrollers with A/D

PIC18F6X2X/8X2X
23.1 Control Register
The Low Voltage Detect Control register
(Register 23-1) controls the operation of the Low
Voltage Detect circuitry.
REGISTER 23-1:
LVDCON REGISTER
U-0
U-0
—
—
bit 7
R-0
IRVST
R/W-0
LVDEN
R/W-0
LVDL3
R/W-1
LVDL2
R/W-0
LVDL1
R/W-1
LVDL0
bit 0
bit 7-6
bit 5
bit 4
bit 3-0
Unimplemented: Read as ‘0’
IRVST: Internal Reference Voltage Stable Flag bit
1 = Indicates that the Low Voltage Detect logic will generate the interrupt flag at the specified
voltage range
0 = Indicates that the Low Voltage Detect logic will not generate the interrupt flag at the
specified voltage range and the LVD interrupt should not be enabled
LVDEN: Low Voltage Detect Power Enable bit
1 = Enables LVD, powers up LVD circuit
0 = Disables LVD, powers down LVD circuit
LVDL3:LVDL0: Low Voltage Detection Limit bits
1111 = External analog input is used (input comes from the LVDIN pin)
1110 = 4.45V - 4.83V
1101 = 4.16V - 4.5V
1100 = 3.96V - 4.3V
1011 = 3.76V - 3.92V
1010 = 3.57V - 3.87V
1001 = 3.47V - 3.75V
1000 = 3.27V - 3.55V
0111 = 2.98V - 3.22V
0110 = 2.77V - 3.01V
0101 = 2.67V - 2.89V
0100 = 2.48V - 2.68V
0011 = 2.37V - 2.57V
0010 = 2.18V - 2.36V
0001 = 1.98V - 2.14V
0000 = Reserved
Note: LVDL3:LVDL0 modes, which result in a trip point below the valid operating voltage
of the device, are not tested.
Legend:
R = Readable bit
- n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared x = Bit is unknown
 2003 Microchip Technology Inc.
Advance Information
DS39612A-page 255