GMS30C2116 Datasheet, PDF (31/322 Pages) Hynix Semiconductor – USERS MANUAL

ARCHITECTURE
1-11
1.2.2 Status Register SR, G1 (continued)
FRM
Floating-Point Rounding Mode. Bits 14..13 are the floating-point rounding
modes (see section 3.33.2. Floating-Point Instructions).
L
Interrupt-Lock Flag. Bit 15 is the interrupt-lock flag L. When the L flag is one,
all Interrupt, Parity Error and Extended Overflow exceptions are inhibited
regardless of individual mode bits. The state of the L flag is effective
immediately after any instruction that changed it. The L flag is set to one by
any exception.
The L flag can be cleared or kept set in any or on return to any privilege state
(user or supervisor). Changing the L flag from zero to one is privileged to
supervisor or return from supervisor to supervisor state. A trap to Privilege
Error occurs if the L flag is set under program control from zero to one in user
or on return to user state.
The following status information can be changed only internally or replaced by the saved
return value of the SR via a Return instruction:
T
Trace-Mode Flag. Bit 16 is the trace-mode flag T. When both the T flag and
the trace pending flag P are one, a trace exception occurs after every instruction
except after a Delayed Branch instruction. The T flag is cleared by any
exception.
Note: The T flag can only be changed in the saved return SR and is then
effective after execution of a Return instruction.
P
Trace Pending Flag. Bit 17 is the trace pending flag P. It is automatically set to
one by all instructions except by the Return instruction, which restores the P
flag from bit 17 of the saved return SR.
Since for a Trace exception both the P and the T flag must be one, the P flag
determines whether a trace exception occurs (P = 1) or does not occur (P = 0)
immediately after a Return instruction that restored the T flag to one.
When an instruction is ended, the T and P flag set to one. Therefore trace
exception is occurred. After trace exception trap is ended the process returns to
main program, and if T and P flag is set to one, trace exception occurs again.
To avoid tracing the same instruction in an endless loop, the P flag is cleared at
return instruction in trace exception trap routine.
Note: The P flag can only be changed in the saved SR. No program except the
trace exception handler should affect the saved P flag. The trace exception
handler must clear the saved P flag to prevent a trace exception on return, in
order to avoid tracing the same instruction in an endless loop.
S
Supervisor State Flag. Bit 18 is the supervisor state flag S (see section
1.4. Privilege States). The S flag determine whether user state (S=0) or
supervisor state (S=1). It is set to one by any exception.
ILC
Instruction-Length Code. Bits 20 and 19 represent the instruction-length code
ILC. It is updated by instruction execution. The ILC holds (in general) the
length of the last instruction: ILC values of one, two or three represent an
instruction length of one, two or three half words respectively. After a branch
taken, the ILC is invalid. The Return instruction clears the ILC.