MC9S12KG128_10 Datasheet, PDF (112/606 Pages) Freescale Semiconductor, Inc – HCS12 Microcontrollers

Chapter 2 128 Kbyte ECC Flash Module (S12FTS128K1ECCV1)
Flash security byte remains in a secured state, any reset will cause the MCU to initialize to a secure
operating mode.
2.6.1 Unsecuring the MCU using Backdoor Key Access
The MCU may be unsecured by using the backdoor key access feature which requires knowledge of the
contents of the backdoor keys (four 16-bit words programmed at addresses 0xFF00–0xFF07). If the
KEYEN[1:0] bits are in the enabled state (see Section 2.3.2.2, “Flash Security Register (FSEC)”) and the
KEYACC bit is set, a write to a backdoor key address in the Flash memory triggers a comparison between
the written data and the backdoor key data stored in the Flash memory. If all four words of data are written
to the correct addresses in the correct order and the data matches the backdoor keys stored in the Flash
memory, the MCU will be unsecured. The data must be written to the backdoor keys sequentially starting
with 0xFF00–0xFF01 and ending with 0xFF06–0xFF07. 0x0000 and 0xFFFF are not permitted as
backdoor keys. While the KEYACC bit is set, reads of the Flash memory will return invalid data.
The user code stored in the Flash memory must have a method of receiving the backdoor key from an
external stimulus. This external stimulus would typically be through one of the on-chip serial ports.
If the KEYEN[1:0] bits are in the enabled state (see Section 2.3.2.2, “Flash Security Register (FSEC)”),
the MCU can be unsecured by the backdoor access sequence described below:
1. Set the KEYACC bit in the Flash configuration register (FCNFG).
2. Write the correct four 16-bit words to Flash addresses 0xFF00–0xFF07 sequentially starting with
0xFF00.
3. Clear the KEYACC bit.
4. If all four 16-bit words match the backdoor keys stored in Flash addresses 0xFF00–0xFF07, the
MCU is unsecured and the SEC[1:0] bits in the FSEC register are forced to the unsecure state of
1:0.
The backdoor key access sequence is monitored by an internal security state machine. An illegal operation
during the backdoor key access sequence will cause the security state machine to lock, leaving the MCU
in the secured state. A reset of the MCU will cause the security state machine to exit the lock state and
allow a new backdoor key access sequence to be attempted. The following operations during the backdoor
key access sequence will lock the security state machine:
1. If any of the four 16-bit words does not match the backdoor keys programmed in the Flash array.
Double bit faults detected while reading the backdoor keys from the Flash array are ignored.
2. If the four 16-bit words are written in the wrong sequence.
3. If more than four 16-bit words are written.
4. If any of the four 16-bit words written are 0x0000 or 0xFFFF.
5. If the KEYACC bit does not remain set while the four 16-bit words are written.
6. If any two of the four 16-bit words are written on successive MCU clock cycles.
After the backdoor keys have been correctly matched, the MCU will be unsecured. After the MCU is
unsecured, the Flash security byte can be programmed to the unsecure state, if desired.
MC9S12KG128 Data Sheet, Rev. 1.16
112
Freescale Semiconductor