C8051F54X_14 Datasheet, PDF (170/275 Pages) Silicon Laboratories – Mixed Signal ISP Flash MCU Family

C8051F54x
19. Local Interconnect Network (LIN)
Important Note: This chapter assumes an understanding of the Local Interconnect Network (LIN) proto-
col. For more information about the LIN protocol, including specifications, please refer to the LIN consor-
tium (http://www.lin-subbus.org).
LIN is an asynchronous, serial communications interface used primarily in automotive networks. The Sili-
con Laboratories LIN controller is compliant to the 2.1 Specification, implements a complete hardware LIN
interface and includes the following features:
 Selectable Master and Slave modes.
 Automatic baud rate option in slave mode.
 The internal oscillator is accurate to within 0.5% of 24 MHz across the entire temperature range and for
VDD voltages greater than or equal to the minimum output of the on-chip voltage regulator, so an
external oscillator is not necessary for master mode operation for most systems.
Note: The minimum system clock (SYSCLK) required when using the LIN controller is 8 MHz.
C8051F540/2/4/6
LIN Controller
LIN Data
Registers
LIN Control
Registers
Indirectly Addressed Registers
8051 MCU Core
LIN0ADR
LIN0DAT
TX
Control State Machine
RX
LIN0CF
Figure 19.1. LIN Block Diagram
The LIN controller has four main components:
 LIN Access Registers—Provide the interface between the MCU core and the LIN controller.
 LIN Data Registers—Where transmitted and received message data bytes are stored.
 LIN Control Registers—Control the functionality of the LIN interface.
 Control State Machine and Bit Streaming Logic—Contains the hardware that serializes messages and
controls the bus timing of the controller.
170
Rev. 1.1