TLK3134_1 Datasheet, PDF (99/150 Pages) Texas Instruments – 4-Channel Multi-Rate Transceiver

www.ti.com
TLK3134
4-Channel Multi-Rate Transceiver
SLLS838D – MAY 2007 – REVISED JULY 2008
exceptions:
• Write 1’b1 to 4/5.32768.2 instead of 4/5.32768.1.
• Write 1’b1 to 4/5.32769.2 instead of 4/5.32769.1.
• Write 1’b0 to 4/5.32809.15 instead of 1’b1.
• 1000Base-X Based High/Mixed/Low Frequency Test Pattern:
– Device Pin Setting(s):
• Ensure ST primary input pin is high.
• Ensure CODE primary input pin is low.
– Reset Device:
• Issue a hard or soft reset (RST_N asserted –or- Write 1 to 0.15)
– Select single ended or differential REFCLK input:
• If Single Ended REFCLK used - Write 2’b01 to 4/5.37120.15:14
• If Differential REFCLK used – Write 2’b00 to 4/5.37120.15:14
– Select SERDES TX Reference Clock Input:
• If Single Ended REFCLK used - Write 2’b10 to 4/5.37120.11:10
• If Differential REFCLK used – Write 2’b11 to 4/5.37120.11:10
– Select SERDES RX Reference Clock Input:
• If Single Ended REFCLK used - Write 2’b10 to 4/5.37120.9:8
• If Differential REFCLK used – Write 2’b11 to 4/5.37120.9:8
– Disable Comma Detection:
• Write 1’b0 to 17.7
– Ensure a legal reference clock operation frequency is selected based on Appendix A, and provision
control settings accordingly. It is also possible to use the Jitter Cleaner during these tests, and the
user should consult Appendix A for further Jitter Cleaner provisioning details.
– Issue Datapath Reset:
• Write 1’b1 to 16.11
– Select Test Pattern:
• If High Frequency Pattern is desired:
– Write 3’b000 to 16.2:0
• If Low Frequency Pattern is desired:
– Write 3’b001 to 16.2:0
• If Mixed Frequency Pattern is desired:
– Write 3’b010 to 16.2:0
– Enable Test Pattern Generation:
• Write 1’b1 to 16.4
– Clear Counters:
• Read 22.15:0 and discard the value.
– Enable Test Pattern Verification:
• Write 1’b1 to 16.3
– Verify Test In Progress:
• Poll 21.1 asserted.
– The pattern verification is now in progress.
– Verify Error Free Operation (as many times as desired during the duration of the test period):
• Read 22.15:0, and verify 16’h0000 is read to confirm error free operation.
• 1000Base-X Based Continuous Random Pattern (CRPAT) Long/Short Test Pattern:
– Device Pin Setting(s):
• Ensure ST primary input pin is high.
Submit Documentation Feedback
Device Reset Requirements/Procedure
99