UPSD3422_06 Datasheet, PDF (51/293 Pages) STMicroelectronics – Turbo Plus Series Fast Turbo 8032 MCU with USB and Programmable Logic

uPSD34xx
Debug unit
up to V_CC as described in the section, Section 28.6.8: Debugging the 8032 MCU
module on page 257.
– The duration of a pulse, generated when the Event pin configured as an output, is
one MCU clock cycle. This is an active-low signal, so the first edge when an event
occurs is high-to-low.
– The clock to the Watchdog Timer, ADC, and I²C interface are not stopped by a
breakpoint halt.
– The Watchdog Timer should be disabled while debugging with JTAG, else a reset
will be generated upon a watchdog time-out.
51/293