MC68HC908GT16 Datasheet, PDF (78/412 Pages) Motorola, Inc – Microcontrollers

Resets and Interrupts
After every instruction, the CPU checks all pending interrupts if the I bit
is not set. If more than one interrupt is pending when an instruction is
done, the highest priority interrupt is serviced first. In the example shown
in Figure 4-5, if an interrupt is pending upon exit from the interrupt
service routine, the pending interrupt is serviced before the LDA
instruction is executed.
CLI
LDA #$FF
BACKGROUND
ROUTINE
INT1
PSHH
PULH
RTI
INT1 INTERRUPT SERVICE ROUTINE
INT2
PSHH
PULH
RTI
INT2 INTERRUPT SERVICE ROUTINE
Figure 4-5. Interrupt Recognition Example
The LDA opcode is prefetched by both the INT1 and INT2 RTI
instructions. However, in the case of the INT1 RTI prefetch, this is a
redundant operation.
NOTE:
To maintain compatibility with the M6805 Family, the H register is not
pushed on the stack during interrupt entry. If the interrupt service routine
modifies the H register or uses the indexed addressing mode, save the
H register and then restore it prior to exiting the routine.
4.4.2 Sources
The sources in Table 4-1 can generate CPU interrupt requests.
Technical Data
78
MC68HC908GT16 • MC68HC908GT8 — Rev. 2
Resets and Interrupts
MOTOROLA