MC68HC908GT16 Datasheet, PDF (105/412 Pages) Motorola, Inc – Microcontrollers

6.5.2 Stop Mode
Break Module (BRK)
Break Module Registers
A break interrupt causes exit from stop mode and sets the SBSW bit in
the break status register.
6.6 Break Module Registers
These registers control and monitor operation of the break module:
• Break status and control register (BRKSCR)
• Break address register high (BRKH)
• Break address register low (BRKL)
• SIM break status register (SBSR)
• SIM break flag control register (SBFCR)
6.6.1 Break Status and Control Register
The break status and control register (BRKSCR) contains break module
enable and status bits.
Address: $FE0B
Bit 7
6
5
4
3
2
1
Bit 0
Read:
0
0
0
0
0
0
BRKE BRKA
Write:
Reset: 0
0
0
0
0
0
0
0
= Unimplemented
Figure 6-3. Break Status and Control Register (BRKSCR)
BRKE — Break Enable Bit
This read/write bit enables breaks on break address register matches.
Clear BRKE by writing a logic 0 to bit 7. Reset clears the BRKE bit.
1 = Breaks enabled on 16-bit address match
0 = Breaks disabled on 16-bit address match
MC68HC908GT16 • MC68HC908GT8 — Rev. 2
MOTOROLA
Break Module (BRK)
Technical Data
105