MC68HC908GT16 Datasheet, PDF (75/412 Pages) Motorola, Inc – Microcontrollers

Resets and Interrupts
Resets
4.3.3.4 Illegal Opcode Reset
An illegal opcode reset is an internal reset caused by an opcode that is
not in the instruction set. An illegal opcode reset sets the ILOP bit in the
SIM reset status register.
If the stop enable bit, STOP, in the mask option register is a logic 0, the
STOP instruction causes an illegal opcode reset.
4.3.3.5 Illegal Address Reset
An illegal address reset is an internal reset caused by opcode fetch from
an unmapped address. An illegal address reset sets the ILAD bit in the
SIM reset status register.
A data fetch from an unmapped address does not generate a reset.
4.3.4 SIM Reset Status Register
This read-only register contains flags to show reset sources. All flag bits
are automatically cleared following a read of the register. Reset service
can read the SIM reset status register to clear the register after power-
on reset and to determine the source of any subsequent reset.
The register is initialized on power-up as shown with the POR bit set and
all other bits cleared. During a POR or any other internal reset, the RST
pin is pulled low. After the pin is released, it will be sampled 32
CGMXCLK cycles later. If the pin is not above a V_IH at that time, then the
PIN bit in the SRSR may be set in addition to whatever other bits are set.
NOTE:
Only a read of the SIM reset status register clears all reset flags. After
multiple resets from different sources without reading the register,
multiple flags remain set.
MC68HC908GT16 • MC68HC908GT8 — Rev. 2
MOTOROLA
Resets and Interrupts
Technical Data
75