MC68HC908GT16 Datasheet, PDF (370/412 Pages) Motorola, Inc – Microcontrollers

Timer Interface Module (TIM)
22.8 TIM During Break Interrupts
A break interrupt stops the TIM counter.
The system integration module (SIM) controls whether status bits in
other modules can be cleared during the break state. The BCFE bit in
the SIM break flag control register (SBFCR) enables software to clear
status bits during the break state. See 19.8.3 SIM Break Flag Control
Register.
To allow software to clear status bits during a break interrupt, write a
logic 1 to the BCFE bit. If a status bit is cleared during the break state, it
remains cleared when the MCU exits the break state.
To protect status bits during the break state, write a logic 0 to the BCFE
bit. With BCFE at logic 0 (its default state), software can read and write
I/O registers during the break state without affecting status bits. Some
status bits have a 2-step read/write clearing procedure. If software does
the first step on such a bit before the break, the bit cannot change during
the break state as long as BCFE is at logic 0. After the break, doing the
second step clears the status bit.
22.9 I/O Signals
Port D shares four of its pins with the TIM. The four TIM channel I/O pins
are T1CH0, T1CH1, T2CH0, and T2CH1 as described in 22.4 Pin Name
Conventions.
Each channel I/O pin is programmable independently as an input
capture pin or an output compare pin. T1CH0 and T2CH0 can be
configured as buffered output compare or buffered PWM pins.
Technical Data
370
MC68HC908GT16 • MC68HC908GT8 — Rev. 2
Timer Interface Module (TIM)
MOTOROLA