MC9S12NE64V1 Datasheet, PDF (297/554 Pages) Freescale Semiconductor, Inc – MC9S12NE64V1 Data Sheet

10.4 Functional Description
This section provides a complete functional description of the IICV2.
Functional Description
10.4.1 I-Bus Protocol
The IIC bus system uses a serial data line (SDA) and a serial clock line (SCL) for data transfer. All devices
connected to it must have open drain or open collector outputs. Logic AND function is exercised on both
lines with external pull-up resistors. The value of these resistors is system dependent.
Normally, a standard communication is composed of four parts: START signal, slave address transmission,
data transfer and STOP signal. They are described briefly in the following sections and illustrated in
Figure 10-9.
MSB
LSB
SCL
1 2 34 5 6 78 9
MSB
LSB
1 2 34 5 6 78 9
SDA
AD7 AD6 AD5 AD4 AD3 AD2 AD1 R/W
XXX D7 D6 D5 D4 D3 D2 D1 D0
Start
Signal
Calling Address
Read/ Ack
Write ^Bit
MSB
LSB
SCL
1 2 34 5 67 89
Data Byte
No Stop
Ack Signal
Bit
MSB
LSB
1 234 5 678 9
SDA AD7 AD6 AD5 AD4 AD3 AD2 AD1 R/W
XX
AD7 AD6 AD5 AD4 AD3 AD2 AD1 R/W
Start
Signal
Calling Address
Read/ Ack
Write ^Bit
Repeated
Start
Signal
New Calling Address
Read/ No Stop
Write
Ack Signal
Bit
Figure 10-9. IIC-Bus Transmission Signals
10.4.1.1 START Signal
When the bus is free, i.e. no master device is engaging the bus (both SCL and SDA lines are at logical
high), a master may initiate communication by sending a START signal.As shown in Figure 10-9, a
START signal is defined as a high-to-low transition of SDA while SCL is high. This signal denotes the
beginning of a new data transfer (each data transfer may contain several bytes of data) and brings all slaves
out of their idle states.
MC9S12NE64 Data Sheet, Rev. 1.1
Freescale Semiconductor
297