MC9S12KG128 Datasheet, PDF (425/600 Pages) Freescale Semiconductor, Inc – Microcontrollers

13.3.2.10 Timer Interrupt Enable Register (TIE)
Chapter 13 Timer Module (TIM16B8CV1)
7
6
5
4
3
2
1
0
R
C7I
C6I
C5I
C4I
C3I
C2I
C1I
C0I
W
Reset
0
0
0
0
0
0
0
0
Figure 13-18. Timer Interrupt Enable Register (TIE)
Read: Anytime
Write: Anytime.
Table 13-12. TIE Field Descriptions
Field
7:0
C7I:C0I
Description
Input Capture/Output Compare “x” Interrupt Enable — The bits in TIE correspond bit-for-bit with the bits in
the TFLG1 status register. If cleared, the corresponding flag is disabled from causing a hardware interrupt. If set,
the corresponding flag is enabled to cause a interrupt.
13.3.2.11 Timer System Control Register 2 (TSCR2)
7
6
5
4
3
2
1
0
R
0
0
0
TOI
TCRE
PR2
PR1
PR0
W
Reset
0
0
0
0
0
0
0
0
= Unimplemented or Reserved
Figure 13-19. Timer System Control Register 2 (TSCR2)
Read: Anytime
Write: Anytime.
Table 13-13. TSCR2 Field Descriptions
Field
7
TOI
3
TCRE
2
PR[2:0]
Description
Timer Overflow Interrupt Enable
0 Interrupt inhibited.
1 Hardware interrupt requested when TOF flag set.
Timer Counter Reset Enable — This bit allows the timer counter to be reset by a successful output compare 7
event. This mode of operation is similar to an up-counting modulus counter.
0 Counter reset inhibited and counter free runs.
1 Counter reset by a successful output compare 7.
If TC7 = 0x0000 and TCRE = 1, TCNT will stay at 0x0000 continuously. If TC7 = 0xFFFF and TCRE = 1, TOF
will never be set when TCNT is reset from 0xFFFF to 0x0000.
Timer Prescaler Select — These three bits select the frequency of the timer prescaler clock derived from the
Bus Clock as shown in Table 13-14.
MC9S12KG128 Data Sheet, Rev. 1.15
Freescale Semiconductor
425