SAM7S256_14 Datasheet, PDF (215/775 Pages) ATMEL Corporation – ARM-based Flash MCU

26. Debug Unit (DBGU)
26.1
Overview
The Debug Unit provides a single entry point from the processor for access to all the debug capabilities of Atmel’s
ARM-based systems.
The Debug Unit features a two-pin UART that can be used for several debug and trace purposes and offers an
ideal medium for in-situ programming solutions and debug monitor communications. Moreover, the association
with two peripheral data controller channels permits packet handling for these tasks with processor time reduced to
a minimum.
The Debug Unit also makes the Debug Communication Channel (DCC) signals provided by the In-circuit Emulator
of the ARM processor visible to the software. These signals indicate the status of the DCC read and write registers
and generate an interrupt to the ARM processor, making possible the handling of the DCC under interrupt control.
Chip Identifier registers permit recognition of the device and its revision. These registers inform as to the sizes and
types of the on-chip memories, as well as the set of embedded peripherals.
Finally, the Debug Unit features a Force NTRST capability that enables the software to decide whether to prevent
access to the system via the In-circuit Emulator. This permits protection of the code, stored in ROM.
SAM7S Series [DATASHEET]
6175M–ATARM–26-Oct-12
215