English
Language : 

SED1374 Datasheet, PDF (68/420 Pages) Epson Company – SED1374 Embedded Memory Color LCD Controller
Page 60
Epson Research and Development
Vancouver Design Center
REG[07h] FPLINE Start Position
Address = FFE7h
n/a
n/a
n/a
Read/Write
FPLINE Start FPLINE Start FPLINE Start FPLINE Start FPLINE Start
Position Bit 4 Position Bit 3 Position Bit 2 Position Bit 1 Position Bit 0
bits 4-0
FPLINE Start Position
These bits are used in TFT/MD-TFD mode to specify the position of the FPLINE pulse.
These bits specify the delay, in 8-pixel resolution, from the end of a line of display data
(FPDAT) to the leading edge of FPLINE. This register is effective in TFT/MD-TFD mode
only (REG[01h] bit 7 = 1). This register is programmed as follows:
FPLINEposition(pixels) = (REG[07h] + 2) × 8
The following constraint must be satisfied:
REG[07h] ≤ REG[08h]
REG[08h] Horizontal Non-Display Period
Address = FFE8h
Horizontal
n/a
n/a
n/a
Non-Display
Period Bit 4
Horizontal
Non-Display
Period Bit 3
Horizontal
Non-Display
Period Bit 2
Horizontal
Non-Display
Period Bit 1
Read/Write
Horizontal
Non-Display
Period Bit 0
bits 4-0
Horizontal Non-Display Period
These bits specify the horizontal non-display period in 8-pixel resolution.
HorizontalNonDisplayPeriod(pixels) = (REG[08h] + 4) × 8
REG[09h] FPFRAME Start Position
Address = FFE9h
FPFRAME
n/a
n/a
Start Position
Bit 5
FPFRAME
Start Position
Bit 4
FPFRAME
Start Position
Bit 3
FPFRAME
Start Position
Bit 2
FPFRAME
Start Position
Bit 1
Read/Write
FPFRAME
Start Position
Bit 0
bits 5-0
FPFRAME Start Position
These bits are used in TFT/MD-TFD mode to specify the position of the FPFRAME pulse.
These bits specify the number of lines between the last line of display data (FPDAT) and
the leading edge of FPFRAME. This register is effective in TFT/MD-TFD mode only
(REG[01h] bit 7 = 1).
FPFRAMEposition(lines)= REG[09h]
The contents of this register must be greater than zero and less than or equal to the Vertical
Non-Display Period Register, i.e.
1 ≤ REG[09h] ≤ REG[0Ah]
SED1374
X26A-A-001-02
Hardware Functional Specification
Issue Date: 99/04/29