SED1374 Datasheet, PDF (186/420 Pages) Epson Company – SED1374 Embedded Memory Color LCD Controller

Page 8
Panel Information
Epson Research and Development
Vancouver Design Center
Figure 2: Panel Information
This section of the 1374CFG dialog describes the panel connected to the SED1374. Each
of the settings are described briefly below.
• Mono / Color – select mono for monochrome panels or color for color panels.
This option is STN specific and is disabled if TFT is selected.
• Single / Dual – select single when connected to a single panel or dual for connection to
a dual panel.
This option is STN specific and is disabled if TFT is selected.
• STN / TFT – select STN for passive panels or TFT for active panels. Switching
between these two panel types causes visible changes to take place to the configuration
dialog box.
• 4 Bit / 8 Bit – here the panel data width is selected. When STN panel types are selected
the options are 4-bit and 8-bit. When TFT panels are selected the options will be 9-bit
and 12-bit.
• Dimensions – in the left selection box horizontal pixels can be chosen from the list or
typed in; in the right selection box, vertical lines, in pixels, can be selected from the list
or typed in.
• Mask FPSHIFT – when selected the panel clocking signal FPSHIFT is masked off.
This option is required for most newer monochrome panels. When color panel type is
selected this option is disabled.
This option is STN specific and is disabled if TFT is selected.
SED1374
X26A-B-001-01
1374CFG.EXE Configuration Program
Issue Date: 98/10/27