M16C26A Datasheet, PDF (209/352 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/Tiny SERIES

M16C/26A Group (M16C/26A, M16C/26B, M16C/26T)
14. A/D Converter
14.1.4 Repeat Sweep Mode 0
In repeat sweep mode 0, analog voltages applied to the selected pins are repeatedly converted to a
digital code. Table 14.1.4.1 shows the repeat sweep mode 0 specifications. Figure 14.1.4.1 shows the
operation example in repeat sweep mode 0. Figure 14.1.4.2 shows the ADCON0 to ADCON2 registers in
repeat sweep mode 0.
Table 14.1.4.1 Repeat Sweep Mode 0 Specifications
Item
Specification
Function
The SCAN1 to SCAN0 bits in the ADCON1 register and the ADGSEL1 to
ADGSEL0 bits in the ADCON2 register select pins. Analog voltage applied to
the selected pins is repeatedly converted to a digital code
A/D Conversion Start Condition • When the TRG bit in the ADCON0 register is “0” (software trigger)
Set the ADST bit in the ADCON0 register to “1” (A/D conversion started)
• When the TRG bit in the ADCON0 register is “1” (Hardware trigger)
The ADTRG pin input changes state from “H” to “L” after setting the ADST bit
to “1” (A/D conversion started)
A/D Conversion Stop Condition Set the ADST bit to “0” (A/D conversion halted)
Interrupt Request Generation Timing None generated
Analog Input Pin
Select from AN0 to AN1 (2 pins), AN0 to AN3 (4 pins), AN0 to AN5 (6 pins),
AN0 to AN7 (8 pins) ⁽¹⁾
Readout of A/D Conversion Result Readout one of the AD0 to AD7 registers that corresponds to the selected pin
NOTE:
1. AN30 to AN32 can be used in the same way as AN0 to AN7. However, all input pins need to belong to
the same group.
•Example when selecting AN0 to AN3 to analog input pins (SCAN1 to SCAN0=012)
A/D conversion started
AN0
AN1
AN2
AN3
AN4
AN5
AN6
AN7
Figure 14.1.4.1 Operation Example in Repeat Sweep Mode 0
A/D pin input voltage
sampling
A/D pin conversion
Rev. 2.00 Feb.15, 2007 ^{page 192} of 329
REJ09B0202-0200